INSTALLATION INSTRUCTIONS
Because each installation is unique to the property, it is not possible to give full details to suit every setting. However the installation should comply with the requirements of the Building Regulations and be made using “best practice” construction methods.
Remember that many fireplace openings will have a supporting lintel. Do not remove this without making provision to support the remaining structure of the building. The Solid fuel cooker must not form any part of the supporting structure.
1. INSTALLING THE COOKER
1.1Remove all packing and temporary transportation fixings from the Solid fuel cooker, check that no parts have been left inside the cooker.
1.2Take care handling the cooker as it is possible damage the enamel finish. The hot plate area may be removed to reduce the weight, but take care not to damage any seals, and beware of any sharp edges when handling the cooker or any parts.
1.3If the cooker is to be placed between combustible work surfaces and cupboards the optional, insulating, side panels must be fitted.
Stovax Part No. |
| Description |
| ||
| Yeoman SF Cooker Insulation | |
|
| Panel 5cm White |
| Yeoman SF Cooker Insulation | |
|
| Panel 5cm Blue |
| Yeoman SF Cooker Insulation | |
|
| Panel 5cm Green |
| Yeoman SF Cooker Insulation | |
|
| Panel 5cm Pebble |
| Yeoman SF Cooker Integral | |
|
| Insulation Panel |
1.4The clearance to any side wall and the firebox side of the cooker should be a minimum of 50mm, to allow the firedoor to open fully.
1.5Decide it the installation is to be top, rear or side flue exit, and fit and seal, with fire cement, the flue collar and blanking plate to suit. The flue collar attaches to the cooker backplate or top plate with fixings supplied. The blanking plates are fixed to the unused flue outlets with fixings supplied.
1.6Lift the cooker into position on the prepared hearth area, taking care not to damage the hearth finish.
1.7Level cooker using adjustable feet.
1.8Connect the cooker to the chimney system, using Stovax enamelled flue pipe and seal the connecting joints. Typical top, rear or side flue connections are shown.
1.9Provision must be made to clean the flue/chimney after the cooker is installed, as it is not possible to clean through the cooker when it is installed.
1.10Provision should be made for flue debris collection and cleaning when the cooker is installed.
10
