J
SUNLINE 2000
SINGLE PACKAGE HEAT PUMPS
INSTALLATION INSTRUCTION
Supersedes:
MODELS B*CH 036 AND 048 (STYLE B) AND MODELS B*CH 060A (STYLE A)
(10 SEER - w/Belt-Drive Option)
(* = 3 or 5)
GENERAL
YORK Model BCH units are single package heat pumps designed for outdoor installation on a rooftop or a slab. Supplemental electric heaters are available as
The units are completely assembled on rigid, permanently attached base rails. All piping, refrigerant charge, and electrical wiring is
The supplemental electric heaters have
Replacement Parts:
•Refer to Parts Manual for complete listing of replacement parts on this equipment.
All forms referenced in this instruction may be ordered from:
Standard Register
Norman, OK 73069
Toll Free: Tel.
APPROVALS
Design certified by U.L. and C.G.A. as follows:
INSPECTION
As soon as a unit is received, it should be inspected for possible damage during transit. If damage is evident, the extent of the damage should be noted on the carrier’s freight bill. A separate request for inspection by the carrier’s agent should be made in writing. Refer to Form
1.For use as a heat pump only unit or a heat pump unit with supplemental electric heat.
2.For outdoor installation only.
3.For installation on combustible material.
REFERENCE
Additional information on the design, installation, operation and service of this equipment is available in the following reference forms:
•
•
•
•
•
•
•
•
LIMITATIONS
CAUTION
THIS PRODUCT MUST BE INSTALLED IN STRICT COMPLIANCE WITH THE ENCLOSED INSTALLATION INSTRUCTIONS AND ANY APPLICABLE LOCAL, STATE, AND NATIONAL CODES INCLUDING, BUT NOT LIMITED TO, BUILDING, ELECTRICAL, AND MECHANICAL CODES.
WARNING
INCORRECT INSTALLATION MAY CREATE A CONDITION WHERE THE OPERATION OF THE PRODUCT COULD CAUSE PERSONAL INJURY O R PRO PERTY DAM AG E .
Installer should pay particular attention to the words: NOTE, CAUTION and WARNING. Notes are intended to clarify or make the installation easier. Cautions are given to prevent equipment damage. Warnings are given to alert installer that personal injury and/or equipment damage may result if installation procedure is not handled properly.