❥✱Ceiling & Floor Type
|
|
|
| l |
|
|
| OPERATION | m |
|
| g | TIMER | J |
|
| DEF./FAN | ||
|
| n | ||
| e | i | ALARM | |
a |
|
| o | |
|
|
| ||
|
|
| MANUAL | |
|
| f |
| k |
p |
|
| Display Panel |
|
|
|
|
| |
| h | d | b |
|
|
|
| ||
|
|
| d |
|
| C |
|
|
|
| c | p |
|
|
|
|
|
|
NOTICE!
The chart based on one model of our product is for reference only, which may be different from the unit you purchased.
NAMES AND FUNCTIONS
a | indoor unit | b | outdoor unit |
|
|
|
|
c | remote controller | d | |
|
|
|
|
e | air flow louver (at air outlet) | f | connecting pipe |
|
|
|
|
g | drain hose | h | air inlet (with air filter in it) |
|
|
|
|
i | installation part | j | DEF./FAN indicator (For cooling and |
|
|
| heating type, it’s DEF., for cooling only |
|
|
| type, it’s FAN) |
|
|
|
|
k | infrared signal receiver | l | operation lamp |
|
|
|
|
m | timer indicator | n | alarm indicator |
|
|
|
|
o | temporary button | p | |
|
|
|
|
PREPARATION BEFORE INSTALLATION
•Before doing any work, check the interior power supply cord and the main breaker capacity are sufficient and the installation area is sufficient and complies with the requirements.
•Check that the power supply available agrees with nameplate voltage.
•Electrical work, wiring and cables must be performed in compliance with national and local wiring codes and standard.
•Do not use the extension cables. In the case extended cables are needed, use the terminal block.
SELECTION OF THE LOCATION
❥✱Select a place which provides the space around the units as shown in the diagram below.
INDOOR UNIT
Dimension |
|
|
|
|
|
| ||
(mm) | 9 | 12 | 18 | 25 | 35 | 45 | 55 | 65 |
A | 2300 | 2300 | 2300 | 2300 | 2300 | 2300 | 2300 | 2300 |
B | 2300 | 2300 | 2300 | 2300 | 2300 | 2300 | 2300 | 2300 |
C | 5 | 5 | 5 | 5 | 5 | 5 | 5 | 5 |
D | 120 | 120 | 120 | 120 | 120 | 120 | 120 | 120 |
OUTDOOR UNIT
Dimension |
|
|
|
|
|
| ||
(mm) | 9 | 12 | 18 | 25 | 35 | 45 | 55 | 65 |
A | 300 | 300 | 300 | 300 | 300 | 300 | 300 | 300 |
B | 2000 | 2000 | 2000 | 2000 | 2000 | 2000 | 2000 | 2000 |
C | 600 | 600 | 600 | 600 | 600 | 600 | 600 | 600 |
D | 300 | 300 | 300 | 300 | 300 | 300 | 300 | 300 |
INSTALLATION
INSTALLATION SITE
❥✱To install the air conditioner in the following types of environments, consult the shop.
• Places with an oily ambient or where steam or soot occurs.
• Salty or corrosive environments such as coastal areas.
• Places where sulfide gas occurs such as hot springs.
The drain from the outdoor unit must be discharged to a place of good drainage.
CONSIDER NUISANCE TO YOUR NEIGHBOURS
FROM NOISES
• A place solid enough to bear the weight of the unit and which does not amplify the operation noise or vibration.
• A place from where the air discharged from
the outdoor unit or the operation noise |
|
will not annoy your neighbours. | To prevent |
|
A place with | interference, |
|
|
|
|
|
|
|
|
| ||
place at least | ||||||||||||
good | 1m away. | |||||||||||
ventilation. |
|
|
| fluorescent | ||||||||
|
|
|
| lamp. TV | ||||||||
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
•For power supply, be sure to use a separate power circuit dedicated to the air conditioner.
•Relocating the air conditioner requires specialized knowledge and skills. Please consult the shop where you bought the air conditioner if relocation is necessary for moving or remodelling.
Hook
Chart 5
1. Fix the hook with tapping screw onto the wall.
(Refer to Chart 6) | Hook |
| |
| Tapping screw |
| Washer |
| <6mm |
2. Hang the indoor unit on the hook. | Chart 6 |