Yorkville Sound YS1011 owner manual Mon 1 Send Masters, Clip LEDs and Solo Switches

Master Sends Section

25.Mon 1 and

2Send Masters, Clip LEDs and Solo Switches

Mon 1 and 2 Master Sends, Clip LEDs and Solo switches are between the summed channel send signals and its designated EQ and Send jack. The Solos and the Clip LEDs are post-master. Once again, the main L/R buss is on Solo when all the other solos are off.

Mon

1 3

2

1

Mon

2 3

2

1

Aux	3
	2
	1

4 5 6

7

8

9

010

45 6

7

8

9

010

45 6

7

8

9

0 10

Mon 1

clip Send

4 5 6

3		7	Solo
2		8
1		9	Active
0	10

Mon 2

clip Send

4 5 6

37 Solo

28

19

0 10 Active

The Clip LEDs indi- cate near-overload conditions. Reduce the appropriate mas- ter Mon Send setting or the channel Mon

clip

Aux

Send

send settings to avoid distortion.

Because the monitor buss Solo is post-master, you hear the final mix through headphones with the Solo Mode in either AFL or PFL. Final monitor mix levels will therefore appear on the VU-Meter in either AFL or PFL.

4 5 6

37

28

19

0 10

26. Aux Send Master and Clip LED

The Aux Send master is an attenuator between the summed channel Aux sends and the Aux Send jack. The Clip LED is post-master.

If the Aux Clip LED becomes active, reduce the Aux Send master setting or the chan- nel Aux send levels to reduce the risk of distortion. Otherwise, set the Aux master as required for the application - high enough to deliver ample signal strength but not too high for the connected unit’s input headroom (check the unit’s input clip indicator).

27. Efx 1 and 2 Send Masters and Clip LEDs

These faders are between the channel Efx sends and either the internal effects processor (Efx 1) or the Efx 2 Send jack (Efx 2). The Clip LEDs are post-fader.

See under Input Channel Features – Efx 1 and 2 Sends for tips about setting up effects.

28. Internal Efx Defeat Footswitch Jack

This regulates internal Efx, Efx 1 and Efx 2. Connect a standard footswitch here (e.g. Apex model AFS-1) to switch the internal effects on and off.

10