Zanussi DE 4744 Operating sequence, Check the filters, Load the dishes, Measure out detergent

Operating sequence

1. Check the filters

Ensure they are clean and properly positioned (see "Maintenance and cleaning").

2. Press the ON-OFF push button

The ON-OFF indicator light will come on.

3. Check that there is rinse aid and salt

The corresponding indicator lights will illuminate if refilling is necessary.

4. Load the dishes

Remove any scraps of food.

Pull the lower basket out and arrange the saucepans, plates and cutlery in it.

Pull the upper basket out and arrange the plates, saucers, glasses and cups etc. in it.

Slide the baskets back into the machine.

5.Ensure that the spray arms can rotate freely.

6.Measure out detergent

Add the required amount of detergent into the dispenser according to the recommended quantity given in the Washing programmes chart.

Important!

If the half load option is selected remember to reduce the quantity of detergent.

Close the detergent dispenser lid.

7. Close the dishwasher door

8a. Setting and starting the programme without DELAY START

Press the push button corresponding to the wanted programme: the indicator light corresponding to the programme illuminates

and the phase indicator lights foreseen for that programme start flashing.

Select, if required, the HALF LOAD option.

The start of the programme will occur after about 6 seconds from the last pressure of a push button (programme or HALF LOAD push button), in this time it is possible to change programme simply pressing the push button of another programme.

Once the programme has started the phase indicator lights will turn off except for the phase under way.

It is possible to interrupt the programme by:

●opening the door

●pressing the ON-OFF push button (in this case all the indicator lights turn off)

Close the door again o press the ON-OFF, the programme will start from the point in which it was interrupted.

8b. Setting and starting the programme with DELAY START

The setting of the delay start occurs before selecting the programme.

Press the DELAY START push button and selected the desired time (3, 6 or 9 hours) until the indicator light corresponding to the chosen

hours flashes.

Press the push button corresponding to the wanted programme: the indicator light corresponding to the programme illuminates

and the phase indicator lights foreseen for that programme start flashing.

The start of the countdown will occur after about 6 seconds from the last pressure of a push button (programme or HALF LOAD push button).

The countdown will decrease with step of 3 hours and you are informed of this by the indicator lights of the hours.

16