...the wash results are not satisfactory The dishes are not clean
● The wrong washing programme has been selected. |
|
● The dishes were arranged in such a way as to stop water reaching all parts of the surface. The baskets must not be overloaded. |
|
● The spray arms do not rotate freely due to wrong arrangement of the load. |
|
● The filters in the base of the washing compartment are dirty or incorrectly positioned. |
|
● Too little or no detergent has been used. |
|
● Where there are limescales deposits on the dishes; the salt container is empty or the wrong level of the water softener has bee | n |
selected. |
|
● The drain hose connection is not correct. |
|
● The salt container cap is not properly closed. |
|
The dishes are wet and dull
●Rinse aid was not used.
●The rinse aid dispenser is empty.
There are streaks, milky spots or a bluish coating on glasses and dishes
●Decrease rinse aid dosing.
Water drops have dried onto glasses and dishes
●Increase rinse aid dosing.
●The detergent may be the cause. Contact the detergent manufacturer’s consumer care line.
If after all these checks, the problem persists, contact your local Service Force Centre, quoting the model (Mod.), product number (PNC) and serial number (S.N.).
This information can be found on the rating plate located on the right hand side of the dishwasher door (see picture).
So that you always have these numbers at hand, we recommend you to make a note of them here:
Mod. : |
PNC : |
S.N. : |
RA08 |
When you contact the Service Force Centre you will need to give the following details:
1.Your name, address and post code
2.Your telephone number
3.Clear and concise details of the fault
4.The model and serial number (found on the rating plate)
5.The purchase date
Please note that a valid purchase receipt or guarantee documentation is required for
Customer Care
Department
For general enquiries concerning your Zanussi appliance or for |
| |
further information on Zanussi products please contact our |
| |
Customer Care Department by letter or telephone at the |
|
|
address below or visit our website at | www | .zanussi.co.uk |
Service and Spare Parts
In the event of your appliance requiring service, or if you wish to purchase spare parts please contact your local Service
Force Centre by telephoning:
08705 929929
Your telephone call will be automatically routed to the Service Force centre covering your post code area.
For the address of your local Service Force Centre and further information about Service Force, please visit the website at www .serviceforce.co.uk
Before calling out an engineer, please ensure you read the details under the heading Something not working.
Customer Care Department |
|
Zanussi |
|
| |
Slough |
|
Berkshire |
|
SL1 1DZ |
|
Tel: 08705 727727 ( | ) |
| * |
*calls to this number may be recorded for training purposes
15