Filling with rinse aid
(Rinse aid dispenser type B)
1.Open the container by turning the lid (A) anticlockwise.
2.Add the rinse aid until the container is completely full. The indicator (B) will be completely dark.
To deactivate the rinse aid indicator light proceed as follows:
(the dishwasher must be switched off)
1. | Press function push buttons | 1 and | 2 simultaneously. |
|
2. | While keeping the function push buttons |
| 1 and | 2 pressed |
BR01 |
Ensure that the lid is closed after every refill.
BR03 |
switch on the dishwasher by pressing the | On/Off push | |
button. |
| |
The | On/Off indicator light comes on. |
|
At the same time, the indicator lights of push buttons |
| |
1 and | 2 start flashing. |
|
SO568
Adjusting the dose
According to the finish and drying results obtained, adjust the dose of rinse aid by means of the 6 position selector (C) (position 1 minimum dosage, position 6 maximum dosage).
3.Press function push button 2, the corresponding indicator light keeps flashing while the indicator light of push button
1 turns off. At the same time the | rinse aid | indicator light |
starts to flash. |
|
|
Increase the dose if there are drops of water or lime spots on the dishes after washing.
The dose is factory set in position 5.
Reduce it if there are sticky whitish streaks on the dishes.
BR02 |
|
|
| SO570 |
4. Press push button | 2 again, the | rinse aid | indicator light turns |
off, this means that the rinse aid indicator light has been |
| ||
deactivated. |
|
|
|
Clean up any rinse aid spilt during filling with an absorbent cloth to avoid excess foaming during the next wash.
Only use branded rinse aid for dishwashers. Never fill the rinse aid dispenser with any other substances (e.g. dishwasher cleaning agent, liquid detergent). This would damage the appliance.
Top up the rinse aid when the rinse aid indicator light on the control panel illuminates.
It is possible to deactivate the rinse aid indicator light (see the following instructions).
5.To memorise the operation, switch off the dishwasher by
pressing the | On/Off | push button. |
To reactivate the rinse aid indicator light follow the same | ||
process until the | rinse aid | indicator light starts to flash. |
7
