Operating sequence
Before washing your first load of laundry, we recommend that you run a cotton cycle at 60°C, with the machine empty, in order to remove any manufacturing residue from the drum and tub.
Pour half a measure of detergent into the main wash compartment and start up the machine.
1. Place the laundry in the drum
Open the door.
Place the laundry in the drum, one item at a time, shaking them out as much as possible.
Close the door.
P1084
2. Measure out the detergent
Pull out the dispenser drawer until it stops. Measure out the amount of detergent recommended by the manufacturer in a graduated cup and pour it into the
main wash compartment 
.
If you wish to carry out the prewash, pour detergent
into the appropriate compartment marked 
.
3. Measure out the additive
If required, pour fabric softener into the compartment
marked 
, without exceeding the «MAX» mark.
4. Switch the machine on
Press the ON/OFF button to switch the machine on. The display will show three blinking dashes or a blinking zero. The light above the button will light up.
0
5.Select the desired programme/ fabric
Press the FABRIC button repeatedly, in order to select the desired programme/fabric. The relevant light will light up.
The lights relevant to the phases that form the programme will light up.
The display will show the duration of the selected programme, calculated on the basis of the maximum load for each type of fabric. The START/PAUSE button light will start flashing.
If the load of laundry to be washed is small, at the beginning of the cycle the display will still indicate the duration relevant to the maximum load. The duration value will be gradually adjusted during the execution of the cycle.
ENGLISH
C0064 |
C0065 |
17
