Something not working?
Problems which you can resolve yourself.
During machine operation it is possible that one of the following alarm codes appears on the display:
-E10: problem with the water supply
-E20: problem with water draining
-E40: door open
Once the problem has been eliminated, press the START/PAUSE button 
to restart the programme. If after all checks, the problem persists, contact your local Service Centre.
|
| Problem |
| Possible cause |
|
|
|
| |
| • | The machine does not start up: | • | The door is not firmly closed. (E40) |
|
|
| • | The machine is not plugged in or there is no power |
|
|
|
| at the socket. |
|
|
| • | The main fuse has blown. |
|
|
| • The START/PAUSE button has not been | |
|
|
|
| depressed. |
|
|
| • The DELAY START option has been selected. | |
|
|
|
| |
| • | The machine does not fill: | • | The water tap is closed. (E10) |
|
|
| • | The inlet hose is squashed or kinked. (E10) |
|
|
| • | The filter in the inlet hose is blocked. (E10) |
|
|
| • | The door is not properly closed. (E40) |
|
|
|
| |
| • | The machine fills then empties | • | The end of the drain hose is too low. Refer to |
|
| immediately: |
| relevant paragraph in “water drainage” section. |
|
|
|
| |
|
|
|
| |
| • | The machine does not empty | • | The drain hose is squashed or kinked. (E20) |
|
| and/or does not spin: | • | The RINSE HOLD option has been selected. |
|
| • | The drain filter is clogged. (E20) | |
|
|
| ||
|
|
| ||
| • There is water on the floor: | • | Too much detergent or unsuitable detergent | |
|
|
|
| (creates too much foam) has been used. |
|
|
| • | Check whether there are any leaks from one of the |
|
|
|
| inlet hose fittings. It is not always easy to see this |
|
|
|
| as the water runs down the hose; check to see if it |
|
|
|
| is damp. |
|
|
| • | The drain hose is damaged. |
|
|
|
| |
| • | Unsatisfactory washing results: | • | Too little detergent or unsuitable detergent has |
|
|
|
| been used. |
|
|
| • | Stubborn stains have not been treated prior to |
|
|
|
| washing. |
|
|
| • | The correct temperature was not selected. |
|
|
| • | Excessive laundry load. |
|
|
|
| |
| • | The machine vibrates or is | • | The transit bolts and packing have not been |
|
| noisy: |
| removed. |
|
| • | The support feet have not been adjusted. | |
|
|
| • | The laundry is not evenly distributed in the drum. |
|
|
| • | Maybe there is very little laundry in the drum. |
|
|
|
|
|
ENGLISH
23
