Installation, Transit devices | Zanussi WIJ1075 instruction

INSTALLATION

All transit bolts and packing must be removed before using the appliance.

You are advised to keep all transit devices so that they can be refitted if the machine ever has to be transported again.

1.	Using a spanner, unscrew and remove the
	rear right-hand bolt.
2.	Lay the machine on its back, taking care not
	to squash the hoses. This can be avoided by
	placing one of the corner packing pieces
	between the machine and the floor.

P0255

3.	Remove the polystyrene base and take off
	the bottom panel by unscrewing the central
	screw.
4.	Carefully remove the right-hand bag.

5.Carefully slide out the other bags.

6.Re-fit the bottom panel using the 4 screws supplied with the door hinges (in the plastic bag) and the previously removed screw.

7.Set the machine upright and remove the two remaining bolts from the back.

8.Pull out the three plastic pegs from the holes into which the bolts were fitted.

9.Plug all the holes with the plugs which you will find in the plastic bag containing the instruction booklet.

P0457

P0016

P0256

P0015

P0453

P0020