Problem |
| Possible cause |
The compressor operates con- |
| The temperature is not set correctly. |
tinually. |
|
|
|
| The door is not closed correctly. |
|
| The door has been opened too fre- |
|
| quently. |
|
| The product temperature is too high. |
|
|
|
|
| The room temperature is too high. |
Water flows on the rear plate of |
| During the automatic defrosting proc- |
the refrigerator. |
| ess, frost defrosts on the rear plate. |
Water flows into the refrigerator. |
| The water outlet is clogged. |
|
| Products prevent that water flows into |
|
| the water collector. |
Water flows on the ground. |
| The melting water outlet does not flow |
|
| in the evaporative tray above the com- |
|
| pressor. |
The temperature in the appliance |
| The temperature regulator is not set |
is too low. |
| correctly. |
The temperature in the appliance |
| The temperature regulator is not set |
is too high. |
| correctly. |
|
| The door is not closed correctly. |
|
| The product temperature is too high. |
|
|
|
|
| Many products are stored at the same |
|
| time. |
|
| There is no cold air circulation in the |
|
| appliance. |
|
|
|
Solution
Set a higher temperature.
Refer to "Closing the door".
Do not keep the door open longer than necessary.
Let the product temperature decrease to room temperature before storage.
Decrease the room temperature.
This is correct.
Clean the water outlet.
Make sure that products do not touch the rear plate.
Attach the melting water outlet to the evaporative tray.
Set a higher temperature.
Set a lower temperature.
Refer to "Closing the door".
Let the product temperature decrease to room temperature before storage.
Store less products at the same time.
Make sure that there is cold air circula- tion in the appliance.
Replacing the lamp
Caution! Disconnect the plug from the mains socket.
1.Remove the screw from the lamp cov- er.
2. Remove the lamp cover (refer to the illustration).
3.Replace the used lamp with a new lamp of the same
8
power (the maximum power is shown on the lamp cover).
4.Install the lamp cover.
5.Tighten the screw to the lamp cover.
6.Connect the plug to the mains socket.
7.Open the door. Make sure that the light comes on.
Closing the door
1.Clean the door gaskets.
2.If necessary, adjust the door. Refer to "Installation".
3.If necessary, replace the defective door gaskets. Con- tact the Service Force Center.
