Replacing the lamp, The compressor operates con- tinually

Problem

Possible cause

The lamp is defective.

The temperature is not set correctly.

The door is not closed correctly.

The door has been opened too fre- quently.

Solution

Refer to "Replacing the lamp".

Set a higher temperature.

Refer to "Closing the door".

Do not keep the door open longer than necessary.

		The product temperature is too high.

		The room temperature is too high.
Water flows on the rear plate of		During the automatic defrosting proc-
the refrigerator.		ess, frost defrosts on the rear plate.
Water flows into the refrigerator.		The water outlet is clogged.
		Products prevent that water flows in-
		to the water collector.
Water flows on the ground.		The melting water outlet does not
		flow in the evaporative tray above the
		compressor.
The temperature in the appli-		The temperature regulator is not set
ance is too low.		correctly.
The temperature in the appli-		The temperature regulator is not set
ance is too high.		correctly.
		The door is not closed correctly.
		The product temperature is too high.

		Many products are stored at the
		same time.
		There is no cold air circulation in the
		appliance.

Let the product temperature decrease to room temperature before storage.

Decrease the room temperature.

This is correct.

Clean the water outlet.

Make sure that products do not touch the rear plate.

Attach the melting water outlet to the evaporative tray.

Set a higher temperature.

Set a lower temperature.

Refer to "Closing the door".

Let the product temperature decrease to room temperature before storage.

Store less products at the same time.

Make sure that there is cold air circula- tion in the appliance.

Replacing the lamp

Caution! Disconnect the plug from the mains socket.

1.Remove the screw from the lamp cov- er.

2. Remove the lamp cover (refer to the illustration).

3.Replace the used lamp with a new

lamp of the same power and specifi- cally designed for household appli- ances (the maxi- mum power is shown on the lamp cover).

4.Install the lamp cover.

5.Tighten the screw to the lamp cover.

6.Connect the plug to the mains socket.