INSTALLATION
POSITION
Place the freezer horizontally on a firm surface, resting on all four plastic feet. Use a wooden block or similar object to compensate for any bumps/holes in the surface.
The room should be dry and adequately ventilated.
If the room temperature exceeds 43°C, or falls below freezing point, the freezer will not function as it should.
Do not place the freezer close to sources of heat, radiators, chimneys, etc., and do not place the freezer in direct sunlight.
If the freezer has been handled standing on end it should be allowed to stand in normal position for about 12 hours before switching it on.
Please ensure that when the appliance is installed it is easily accessible for the engineer in the event of a breakdown.
SWITCHING ON
Before switching on, the freezer should be cleaned inside. See under “Maintenance”.
Set the thermostat button in middle position. Allow the freezer to run for several hours before placing food inside.
ELECTRICAL REQUIREMENTS
Before switching on, make sure that the voltage of your electricity supply is the same as that indicated on the rating plate, located inside the lid.
Warning:
This appliance must be earthed.
4
