Adjusting the Level of Conductivity
Water contains, a variable quantity of limestone and mineral salts of which quantities vary according to geographical locations thus varying its conductivity values.
Relevant variations of the conductivity of the water compared to those prefixed by the factory could slightly influence the residual humidity of the laundry at the end of the cycle.
Your dryer allows you to regulate the sensitivity of the drying sensor based on conductivity values of the water by using the following procedure.
Procedure:
Turn the programme selector dial to switch on the appliance.
In selection mode press the «Option» button until the Set Up menu appears on the display.
Press «Change» button to enter in the Set Up menu and then press the «Option» button sequentially until the message «Water hardness» appears.
Adjusting the level of conductivity:
Pressing «Change» button you can choose the required water hardness degree.
The level of water hardness is indicated by 3 degree shown on the display: hard, normal and soft.
Water Harness |
|
|
| |
Hard |
|
|
|
|
Soft |
|
|
|
|
Normal |
|
|
|
|
Door | Spin | Options | Change | Exit |
Display | Conductivity degree | Approximative value |
|
| ºdH |
S O F T | Low | < 14 |
|
|
|
N O R M A L | Medium | 15 - 21 |
|
|
|
H A R D | High | > 21 |
|
|
|
Memorising the new setting:
To fix your choice press the «Exit»button. The previous selected drying cycle and options appears again on the display and the buzzer sounds.
Water Harness |
|
|
| |
Hard |
|
|
|
|
Door | Spin | Options | Change | Exit |
Cotton extra |
|
| 08.30 | |
Cycle end at |
|
| 10.55 | |
| 1200 |
|
|
|
Door | Spin | Options | Change | Exit |
Normally, the appliance is
22
