Installation
Preparing the outer door
Screw the guide rods and hinges on the door into place using the predrilled holes.
Mounting plate
Before installing the dishwasher and adjusting the door onto the cupboard, put the mounting plate into its correct position on the shelf.
1. Place the mounting plate in the middle of the cupboard. Mark the holes for screws and the holes for dismounting the outer door. There is a middle mark on the plate to help you.
2.Drill 4 holes with a diameter of 7 mm. The door can be disconnected if necessary, through hole
1(two holes).
3.Then screw the plate into place from under- neath using the 2 screws provided, with the washers between.
4.Snap the hinges into the brackets on the mounting plate.
The outer door should be supported under- neath in order to prevent the hinges from breaking off.
5.Adjust the door to surrounding doors using screws A, B and C.
2x
4x
A B
C
1
1
C
- 18 -
