Drain hose
Connect drain hose to the sink. Secure it with the supplied hose clamp.
Required height: 30 to 100 cm above bottom of the dishwasher.
Ensure that the hoses are not kinked, crushed or entangled.
When connecting the drain hose to an under sink trap spigot, the en-
tire plastic membrane
(A)must be removed. Failure to remove all the membrane will result in food particles building up over time eventually blocking the dishwasher drain hose spigot.
If you use a drain hose extension the total length should not be longer than 4 metres. Likewise the internal diameter of the couplings used for connections to the waste outlet must be no smaller than the diameter of the hose provided.
Electrical connection
CAUTION!
Safety standards require the appliance to be earthed.
Prior to using the appliance for the first time, ensure that the rated voltage and type of supply on the rating plate match that of the supply where the appliance is to be installed.
The fuse rating is also to be found on the rating plate.
24
Always plug the mains plug into a correctly in- stalled shockproof socket.
This could constitute a fire hazard through over- heating.
If necessary, have the domestic wiring system socket replaced. In case that the electrical ca- ble has to be replaced, contact your local Serv- ice Force centre.
The plug must be accessible after the appliance has been installed.
Never unplug the appliance by pulling on the cable. Always pull the plug.
The manufacturer accepts no liability for failure to observe the above safety precautions.
