156999480en.qxp 3/2/2006 8:11 AM Pagina 9
Setting the water softener electronically (see table)
The water softener is factory set at position 5.
The dishwasher must be switched off. Switch on the dishwasher by pressing the On/Off button.
Press and hold simultaneously function buttons 2 and 3 until the lights of function buttons 1, 2 and 3 start flashing.
Release the buttons and then press function button
1; the lights of function buttons 2 and 3 turn off while function button 1 goes on flashing. At the same time End of programme light starts to flash.
The number of flashes of the End of programme light corresponds to the current level.
The End of programme light might flash 5 times, for example. The flashing is repeated every 5 seconds.
To change the level, press function button 1. Each time the button is pressed the level increases. (Level 1 follows level 10).
The End of programme light indicates the new setting. (For the selection of the new level see the chart).
To memorise the operation, switch off the dishwasher by pressing the On/Off button.
9
