156999480en.qxp 3/2/2006 8:11 AM Pagina 23
Electrical connection
WARNING!
Safety standards require the appliance to be earthed. The manufacturer accepts no liability for failure to observe the above safety precautions.
Prior to using the appliance for the first time, ensure that the rated voltage and type of supply on the rating plate match that of the supply where the appliance is to be installed. The fuse rating is also to be found on the rating plate.
Always plug the mains plug into a correctly installed shockproof socket.
WARNING!
If necessary, have the domestic wiring system socket replaced. In case that the electrical cable has to be replaced, contact your local Service Force centre.
The plug must be accessible after the appliance has been installed.
Never unplug the appliance by pulling on the cable. Always pull the plug.
Fitting under a counter
By removing the dishwasher’s worktop, you can install it under a close fitting sink unit or a pre- existing top.
Be sure that once the appliance has been installed, it is easily accessible for the service engineer in the event that a repair is required.
Unscrew the two screws | Push the top backwards | Lift top at the front and |
at the rear. | about 1 cm. | remove it. |
Levelling
Good levelling is essential for correct closure and sealing of the door.
When the appliance is correctly levelled, the door will not catch on either side of the cabinet.
Check if the dishwasher | If not, loosen or tighten |
is levelled. | the adjustable feet until |
| the appliance is |
| perfectly levelled. |
23
