This dishwasher is designed to be fitted under a kitchen counter or work surface.
No further openings for the venting of the dishwasher are required, but only to let the wa- ter fill and drain hose and power supply cable pass through.
The dishwasher incorporates adjustable feet to allow the adjustment of the height.
During all operations that involve accessibility to internal components the dishwasher has to be unplugged.
Be sure that once the appliance has been in- stalled, it is easily accessible for the service engineer in the event that a repair is required.
Levelling
Good levelling is essential for correct closure and sealing of the door.
When the appliance is correctly levelled, the door will not catch on either side of the cabinet. If the door does not close correctly, loosen or tighten the adjustable feet until the machine is perfectly level. (See enclosed template).
Water connection
WARNING!
The dishwasher must not be connected to open water appliances or instantaneous water heat- ers. This dishwasher may be fed with either hot (max. 60°) or cold water. Nevertheless we ad- vise you a cold water supply.
WARNING!
Only use, for connection to the water mains, new
CAUTION!
If the machine is connected to new pipes or pipes which have not been used for a long time, you should run the water for a few minutes be- fore connecting the inlet hose.
Water inlet hose with safety valve
Connect the inlet hose to a water tap with an external thread of 3/4”.
After connecting the
If the water inlet hose leaks, the safety valve cuts off the water supply.
WARNING!
The electrical cable for the safety valve is in the
Take care when installing the water inlet hose
. Place the water inlet hose in such a way that it is always lower than the bottom edge of the safety valve.
If the water inlet hose or the safety valve is damaged, remove the mains plug immediately.
CAUTION!
A water inlet hose with safety valve MUST only be replaced by your local Service Force Centre.
25
