Once these checks have been carried out; close the dishwasher’s door and switch on the appliance. Press the button of the programme that was running before the intervention of the alarm. The programme will continue from the point at which it was interrupted.
If the malfunction or fault code reappears con- tact the Service Force Centre.
For other fault codes not described in the above chart, please contact your Service Force Cen- tre.
Contact your local Service Force Centre, quot- ing the model (Mod.), product number (PNC) and serial number (S.N.).
This information can be found on the rating plate located on the side of the dishwasher door.
So that you always have these numbers at hand, we recommend you to make a note of them here:
Mod. : . . . . . . . . . . . . . . . . . . . . . . .
PNC :. . . . . . . . . . . . . . . . . . . . . . . .
S.N. : . . . . . . . . . . . . . . . . . . . . . . . .
The wash results are not satisfactory
The dishes are not clean
The dishes are wet and dull
There are streaks, milky spots or a bluish coating on glasses and dishes
Water drops have dries onto glasses and dishes
•The wrong washing programme has been selected.
•The dishes are arranged in such a way as to stop water reaching all parts of the surface. The baskets must not be overloaded.
•The spray arms do not rotate freely due to incorrect arrangement of the load.
•The filters in the base of the washing compartment are dirty or incorrectly positioned.
•Too little or no detergent has been used.
•Where there are limescales deposits on the dishes; the salt container is empty or the incorrect level of the water softener has been set.
•The drain hose connection is not correct.
•The salt container cap is not properly closed.
•Rinse aid was not used.
•The rinse aid dispenser is empty.
•Decrease rinse aid dosing.
•Increase rinse aid dosing.
•The detergent may be the cause. Contact the de- tergent manufacturer’s consumer care line.
If after all these checks, the problem persists, contact your local Service Force Centre.
22
