Zanussi ZGS 682 ICT manual Using the hob correctly, Burner, minimum, maximum

Models: ZGS 682 I ZGS 682 IC ZGS 682 ICT

1 36
Download 36 pages 40.04 Kb
Page 9
Image 9
Do not keep the control knob pressed for more than 15 seconds.

Do not keep the control knob pressed for more than 15 seconds.

If the burner does not light even after 15 seconds, release the control knob, turn it the "off" position and wait for at least one minute before trying to light the burner again.

When switching on the mains, after installation or a power cut, it is quite normal for the spark generator to be activated automatically.

In the absence of electricity, ignition can occur without the electrical device; in this case, approach the burner with a flame, push the relevant knob down and turn it anti-clockwise until it reaches the maximum position.

If the control knobs become difficult to turn, please contact your local Service Force Centre.

Using the hob correctly

To ensure maximum burner efficiency, it is strongly recommended that you use only pots and pans with a flat bottom fitting the size of the burner used, so that flame will not spread beyond the bottom of the vessel (see the table below).

Burner

minimum

maximum

 

diameter

diameter

Triple crown

180 mm

260 mm

Medium (semi-rapid)

120 mm

220 mm

Medium (front - left)

120 mm

180 mm

Small (auxiliary)

80 mm

160 mm

 

 

 

9

Page 9
Image 9
Zanussi ZGS 682 ICT manual Using the hob correctly, Do not keep the control knob pressed for more than 15 seconds, Burner