WARNING!
This appliance must be installed by a qualified electrician / competent person (CORGI Regis- tered). Safety may be impaired if installation is not carried out in accordance with these in- structions. Do not alter the electrical circuitry of this appliance.
Provision for ventilation
•This appliance is not connected to a com- bustion products evacuation device. It should be installed and connected in ac- cordance with the current installation regu- lations. Particular attention should be given to the relevant requirements regarding ven- tilation.
•The room containing the appliance should have an air supply in accordance with BS. 5440: Part 2 Current Edition. All rooms re- quire an openable window or equivalent and some rooms will require a permanent vent as well. For room volumes up to 5m³ an air vent of 100cm² is required: for room volumes between 5m³ and 10m³ an air vent of 50cm² is required. . If the room has a door that opens directly to the outside, no air vent is required. For room volumes that exceed 11m³ no air vent is required. If there are other fuel burning appliances in the same room, BS.5440: Part 2 Current Edition should be consulted to determine the requisite air vent requirements.
•Prolonged intensive use of the appliance may call for additional ventilation, for exam- ple opening a window, or more effective ventilation, for example increasing the level of mechanical ventilation where present.
Moving your appliance
•You may damage some soft or badly fitted floor coverings when you move the appli- ance. The floor covering under the appliance should be securely fixed so it does not ruck up when you move the appliance across it. Alternatively you could remove the floor cov- ering. This appliance is heavy and care must be taken when moving it. Do not try to move the appliance by pulling the door handles.
•To move the appliance, open the grill door. Raise the appliance off its front feet by lifting it from inside the oven. Pull the appliance forward. When you replace the appliance push it back to the stop and make sure there is the same gap at each rear corner.
For your safety
•Do not try to disconnect the appliance from the gas supply if the supply pipe does not have a bayonet connection, as described in the installation instructions. If this is the case contact the person who installed the appli- ance.
Location of appliance
•This appliance must not be installed in a bed- sitting room of volume less than 20m³ or in a bathroom, shower room or garage. It is essential that the appliance is positioned as shown.
29
