3.Check the supply pressure by turning the Rapid burner on and one other hob burner full on and light the appropriate burner.
The pressure should be either:
–For Natural Gas 20mbar
–For LP. Gas. The pressure must be set to 29 mbar for use on butane or 37 mbar for use on propane.
4.Turn off the taps, disconnect the pressure gauge.
5.Check operation of each hob burner.
Checking the grill
•Place the grill pan containing the grid, with the handle attached, into the grill compart- ment. To light the grill burner push in and hold the control knob, turn to the large flame symbol (highest setting). Press the ignition button immediately. Keep the control knob depressed for up to 5 seconds, but no longer than 10 seconds. After this time release the controls. The flame should remain alight. If after 10 seconds the burner has not lit, stop operating the appliance and wait at least 1 minute before attempting a further ignition of the burner. When the burner has lit release the control and ignition button, adjust the setting as required.
Checking the hob
•Lift the lid. Fit the burner crowns and caps ensuring that they are correctly seated. Fit the pan supports.
•To light the hob burner push in and hold the control knob, turn to the large flame symbol (highest setting). Press the ignition button immediately. If the appliance is equipped with, FSD you can also check the FSD sys- tem by the following procedure: keep the
32
control knob depressed for up to 5 seconds, but no longer than 10 seconds. After this time release the controls. The flame should re- main alight. If after 10 seconds the burner has not lit, stop operating the appliance and wait at least 1 minute before attempting a further ignition of the burner. When the burner has lit release the control and ignition button, adjust the setting as required. Turn off the hob and wait 1 minute. Turn the hob control knob to the large flame symbol (high- est setting). DO NOT depress or attempt to ignite the burner. No gas should flow.
Checking the main oven
1.To light the main oven burner push in and hold the control knob, turn to gas mark 9 Press the ignition button immediately. Keep the control knob depressed for up to 5 seconds, but no longer than 10 seconds. After this time release the controls. The flame should remain alight. If after 10 sec- onds the burner has not lit, stop operating the appliance and wait at least 1 minute before attempting a further ignition of the burner. When the burner has lit release the control and ignition button.
2.After 1 minute check that the flame covers the full width of the burner and is stable.
3.Set the oven control to Mk 2, close the oven door and check that after about 10 minutes the flame size has reduced.
4.Turn off the control and check that the oven flames go out.
Checking lid shut-off device
1.Lift the lid.
2.To light the hob burner push in and hold the control knob, turn to the large flame symbol
