Zanussi ZKG6040ZKG6040WFN Moving your appliance, For your safety, Location of appliance

Moving your appliance

•You may damage some soft or badly fitted

floor coverings when you move the appliance. The floor covering under the appliance should be securely fixed so it does not ruck up when you move the appliance across it. Alternatively you could remove the floor covering. This appliance is heavy and care must be taken when moving it. Do not try to move the appliance by pulling the door handles.

•To move the appliance, open the grill door. Raise the appliance off its front feet by lifting it from inside the oven. Pull the appliance forward. When you replace the appliance push it back to the stop and make sure there is the same gap at each rear corner.

For your safety

•	Do not try to disconnect the appliance from	• Shelves, wall cabinets and cooker hoods
	the gas supply if the supply pipe does not	must be fitted a minimum of 650mm directly
	have a bayonet connection, as described in	above the top of the hob (or greater for
	the installation instructions. If this is the case	cooker hoods if recommended by
	contact the person who installed the	manufacturers instructions) and 400mm
	appliance.	above the hob when fitted in line with the
Location of appliance		outside of the appliance. If the units are
		intended to be fitted adjacent to the
•	This appliance must not be installed in a	appliance but
		less than
	bed-sitting room of volume less than 20m3 or
		400mm
	in a bathroom, shower room or garage. It is
		above the
	essential that the appliance is positioned as
		hob, then a
	shown.
		minimum
		space of
		50mm must
		be
		maintained
		between the
		sides of the
		unit and the
36		appliance.