Installing into a kit chen worksurface
Make a note of the serial number on the ap- pliance rating plate prior to installation. This number will be required in the case of requests for service and is no longer accessible after in- stallation, as it is on the original rating plate on the underside of the appliance.
Installation
1.Cut out the worktop according to the dimensions quoted (Fig.1). (Saw exactly along the line.)
2.Fix according to Fig. 2
Position A must be used for screwing±on the catch springs (Fig.1).
Important: The screw must be driven into the worktop as illustrated.
Avoid overtightening. Do not use electric or pneu- matic screwdrivers unless they have, adjustable slipping clutches (set to 1±1.1 Nm).
fig.1
49
A
A
A A
A 
A
3.Check the sealing for proper fit and full contact.
4.Place the ceramic hob in the cut±out.
fig.2
49
1 | Catch spring | 4 | Frame |
2 | Screws | 5 | Sealing tape |
3 | Worktop | 6 | Glass ceramic plate |
60
