Zanussi ZSF 6171 manual What to do if, Remedying small malfunc- tions, Bottom spray arm

Bottom spray arm

1.To remove bottom spray arm, pull it upwards out of its catch.

2.Clean spray arm jets.

3.Place bottom spray arm back in position against connecting piece and press down firmly, until you feel it snap into place.

What to do if...

Remedying small malfunc- tions

If one of the following fault codes is displayed in the multi-display during operation:

–Fault codeÅ 10 (Problems with water inlet),

–Fault codeÅ 20 (Problems with water drainage), please have a look at the following table.

When the fault is remedied, press the button for the cycle that has started. The cycle will continue.

With other fault codes (“Å ” followed by a number):

–Abort the dishwashing cycle.

–Switch the appliance off and on again.

–Re-set the dishwashing cycle.

If the fault is displayed again, please contact your lo- cal Service Force Centre and inform them of the fault code.

Malfunction	Possible cause	Remedy
	Water tap is blocked with limescale	Check the water tap and have it re-
	or faulty.	paired if necessary.
	The tap is turned off.	Turn the tap on.
	The filter (where present) in the	Clean the filter in the threaded hose
	threaded hose fitting on the tap is
The cycle indicator for the select-		fitting.
	blocked.
ed dishwashing cycle is flashing:
		Cancel the dishwashing cycle (see
the control indicator Water is lit,
fault code Å 10 is displayed in the		chapter: Starting a dishwashing cy-
multi-display	Filters in the base of the washing	cle),
(Problems with water inlet).		clean filters (see chapter: Cleaning
	compartment are blocked.
		the filters),
		then start the dishwashing cycle
		again.
	Water inflow hose	Check the position of the hose.
	has not been correctly positioned.

28