Zanussi ZSF 6171 Setting electronically, Water hardness, Adjusting the hardness setting, Range

Setting electronically:

1.Press the ON/OFF button.

3If indicators for the programme buttons are lit, a dishwashing cycle is activated. The dish- washing cycle must be deselected:

Press function buttons 1 and 2 simultaneously for approx. 2 seconds.

All additional wash programme button indica- tors will go out.

2.Press function buttons 1 and 2 simultaneously and keep them pressed.

The LED indicators for function buttons 1 to 3 will flash.

3.Press function button 1.

The LED indicator for function button 1 will flash. The multi-display will indicate the hardness setting.

4.Pressing function button 1 increases the hard- ness setting by 1.

(Exception: hardness setting 1 follows hardness setting 10).

5.When the hardness setting is correct, press the ON/OFF button.

The hardness setting is now saved.

If the water softener is set electronically to “1”, this switches off the control indicator for dishwasher salt.

	Water hardness		Adjusting the hardness setting		Indication on the
in °d1)	in mmol/l2)	Range	Manual	Electronic	multi-display
51 - 70	9,0 - 12,5			103)	10L .
43 - 50	7,6 - 8,9			9	9L
37 - 42	6,5 - 7,5	IV	1	8	8L
29 - 36	5,1 - 6,4			7	7L
23 - 28	4,0 - 5,0			6	6L
19 - 22	3,3 - 3,9	III		5	5L
15 - 18	2,6 - 3,2			4*	4L
11 - 14	1,9 - 2,5	II	0*	3	3L
4 - 10	0,7 - 1,8	I/II		2	2L
below 4	below 0.7	I		1	1L
				no salt necessary

1)(°d) German degree, measure of the hardness of water

2)[mmol/l] millimol per litre, international unit for water hardness

3)On this setting the length of the dishwashing cycle may be slightly longer. *) factory setting

10