The furniture door
The door on this appliance is designed for the overlay of a panel having the following dimensions:
Width: | 596 mm |
Height: | 664 - 724 mm max |
Thickness: | 20 mm max |
Weight: | 2 - 7.5 kg max |
The panel height should be no more than indicated, otherwise complete opening of the door will no longer be possible as the panel hits against the dishwasher plinth.
Mounting the furniture door onto the door
The height of the panel depends on the height of adjacent kitchen units (see kitchen plinth adjustment). The panel must be fitted with a handle, as the dishwasher handle will be hidden by the panel. Drill the panel with a Ø 2 x 14 bit according to the dimensions indicated in the figure.
Screw the two fastening pivots in the holes indicated in the figure.
Mount the decor panel by inserting the two fastening pivots into the slotted holes of the door. Lift the decor panel until perfect alignment with the fascia panel is obtained.
Once the correct position has been found, open the door and fasten the decor panel by means of the six 4 x 40 screws provided, using the holes through the inner door.
| 596 max |
|
|
| 187 |
= | 525 | = |
II92 |
|
|
II79 |
II80 |
Securing to the adjacent units
To prevent the dishwasher tilting, it must be secured to either the worktop or adjacent kitchen cabinet/wall using the brackets supplied.
Insert the two fixing brackets into the slots provided in the top front part of the dishwasher as shown in the figure.
Secure the brackets to the adjacent units with the 3.5 x 16 screws using the upper or the side holes.
The appliance must be secured to the underside of the underside of the worktop using the brackets provided. Failure to do this could cause damage or injury.
30
II54 |
PFI16/2UK |
