Zanussi ZUT 125W manual Maintenance & Cleaning, Internal Cleaning, External Cleaning, Defrosting

Models: ZUT 125W

1 20
Download 20 pages 52.73 Kb
Page 10
Image 10
Maintenance & Cleaning

Maintenance & Cleaning

Before any maintenance or cleaning is carried out you must DISCONNECT the appliance from the electricity supply.

Internal Cleaning

Clean the inside and accessories with warm water and bicarbonate of soda (5 ml to 0.5 litre of water).

Rinse and dry thoroughly.

NEVER use detergents, abrasive powders, highly perfumed cleaning products or wax polishes to clean the interior as these will damage the surface and leave a strong odour.

)To carry out complete defrosting:

1.Disconnect the appliance from the electrical supply. If the plug is inaccessible turn the thermostat control knob to << Internal Cleaning >>.

2.Remove any stored food, wrap in several layers of newspaper and store in a cool place.

3.Leave the door open.

4.Carefully draw the plastic drain spout out of the lower part of the appliance according to the direction of the arrow and place a tray of a suitable size in the position shown.

External Cleaning

Wash the outer cabinet with warm soapy water.

Once or twice a year dust the condenser (black grille) and the compressor at the back of the appliance with a brush or vacuum cleaner, as an accumulation of dust will affect the performance of the appliance and cause excessive electricity consumption.

When the Appliance is not in Use

When the appliance is not in use for long periods, disconnect from the electricity supply, empty all foods and clean the appliance, leaving the door open to prevent unpleasant smells.

Defrosting

The freezer compartment will become progressively covered with frost. This should be removed with the special plastic scraper provided whenever the thickness of frost exceeds 6mm (¼”).

During this operation it is not necessary to switch off the power supply or to remove the foodstuffs.

However, when the ice becomes very thick on the inner liner, complete defrosting should be carried out and it is advisable to perform this operation when the appliance is empty.

5.During defrosting, push the defrost water towards the edge of the cooling plates using a dry cloth or a sponge. It will be collected at the bottom of the appliance, from where it can be diverted into the tray and then disposed of.

6.To accelerate the defrosting process place a bowl of hot (not boiling) water inside the freezer and close the door.

7.When defrosting is completed, dry the interior thoroughly, replace the drain spout and close the door.

8.Turn the thermostat control knob back to a medium setting and leave to run for at least 4 hours with the 'fast freeze' switch on.

9.Replace the previously removed food.

Important

A temperature rise of the frozen food packs during defrosting may shorten their safe storage life.

Never use sharp metal tools to scrape off frost from the evaporator as this could damage the appliance beyond repair.

10

Page 10
Image 10
Zanussi ZUT 125W manual Maintenance & Cleaning, Internal Cleaning, External Cleaning, When the Appliance is not in Use