IMPORTANT!
The door will be locked throughout the delay time. If you need to open the door, you must first set the washing machine to PAUSE by pressing the Start/Pause button, wait until the «Lock» pilot light goes off. After you have closed the door, press the Start/Pause button again.
Note!
The Delay Start cannot be selected with Drain programme.
Altering an option or a running programme
It is possible to change any option before the programme carries it out.
Before you make any change, you must pause the washing machine by pressing the Start/Pause button.
Changing a running programme is possible only by resetting it. Turn the programme selector dial to Off and then to the new programme position. Start the new programme by depressing the Start/Pause button again.
The washing water in the tub will not emptied out.
Interrupting a programme
Depress the Start/Pause button to interrupt a programme which is running, the corresponding light starts to flash. Depress the button again to restart the programme.
Cancelling a programme
Turn the selector dial to Off to cancel a programme which is running. Now you can select a new programme.
Opening the door after the programme has started
First set the machine to pause by pressing the Start/Pause button.
If the «Lock» light goes off, the door can be opened.
If the «Lock» light does not switch off, this means that the machine is already heating, that the water level is above the bottom edge of the door or that the drum is turning.
In this case the door can not be opened.
If you cannot open the door but you need to open it you have to switch the machine off by turning the selector dial to «Off». After about 3 minutes the door can be opened (pay attention to the water level and temperature!).
At the end of the programme
The machine stops automatically. The Start/Pause light goes off, the «Lock» light goes off and on the display will appear a flashing «0.00». The door can be opened.
If the «Rinse hold» or «Night Cycle» option has been selected, the «Lock» light remains alight and the door is locked to indicate that the water must be emptied out before opening the door.
The display will show a flashing «0.00».
To empty out the water please read the steps on the Rinse Hold option paragraph.
Turn the programme selector dial to «Off» to switch the machine off.
Remove the laundry from the drum and carefully check that the drum is empty.
If you do not intend to carry out another wash, close the water tap. Leave the door open to prevent the formation of mildew and unpleasant smells.
20