Installation instruction
Unpacking
All transit bolts and packing must be removed before using the appliance.
You are advised to keep all transit devices so that they can be refitted if the machine ever has to be transported again.
1.After removing all the packaging, carefully lay machine on it’s back to remove the polystyrene base from the bottom.
2.Remove the power supply cable and the draining hose from the hose holders on the rear of the appliance.
5.Remove the bracket D, refit the six smaller bolts C and slide out the relevant plastic spacer E.
6.Open the porthole, take out the inlet hose from the drum and remove the polystyrene block fitted with the adhesive tape on the door seal.Open the porthole, take out the inlet hose from the drum and remove the polystyrene block fitted with the adhesive tape on the door seal.
7.Fill the smaller upper hole and the two large ones with the corresponding plastic plug caps supplied in the bag containing the instruction booklet.
A |
C
B
B
C 
Positioning
Install the machine on a flat hard floor. Make sure that air circulation around the machine is not impeded by carpets, rugs etc. Check that the machine does not touch the wall or other kitchen units. Level the washing machine by
3.With a suitable spanner unscrew and remove the central rear bolt A.
4.Unscrew and remove the two large rear bolts B and the six smaller bolts C.
E 
C D 
C 
raising or lowering the feet. The feet may be tight to adjust as they incorporate a self locking nut, but the machine MUST be level and stable.
If necessary, check the setting with a spirit level.
Any necessary adjustment can be made with a spanner.
Accurate levelling prevents vibration, noise and displacement of the machine during operation.Never place cardboard, wood or similar materials under the machine to compensate for any unevenness in the floor.
28
