Zebra Technologies Card thickness, P720 Plastic Card Printer, Dual-sided Lamination

Card

Printer

Solutions

P720 Plastic Card Printer

Dual-sided Lamination

General information Getting started Operation Printing a card Cleaning Troubleshooting Specifications Appendix A Appendix B Appendix C

B- CARD THICKNESS CONTROL LEVER

This items is operated by the user to prevent more than one card feeding into the printer at the same time and causing a jam.

Open cover, and adjust lever to the correct position for the card thickness you are using. Repeat for different card thickness. (Factory setting is for 30 mil (0,762 mm) card thickness). See diagram below:

Card thickness:

A - 50mil (1.27mm)

B - 40mil (1.016mm)

C - 30mil (0.762mm)

Note: When laminating cards, always use 30 mil PVC Composite Cards.

C- CARD OUTPUT HOPPER

This items is used for printing cards.

19	Install card Output hopper onto printer by hooking over bottom edge of card
	exit aperture.