9.Refer to Figure 7. If it’s not already in place, install the tear bar in the media access door. Gently lift the tab on the bar to move it over the protrusion on the door. Make sure the lip of the bar (inset, Figure 7) faces out of the printer.
If you’re using direct thermal media, continue on with step 10. However, if you’re using thermal transfer media, you must also install a ribbon cartridge. Proceed to “Loading the Ribbon “ in this chapter.
Tab
Protrusion
Lip
FIGURE 7
10.Close the printhead and the top cover.
11.Swing up the media access door, ensuring that the media ex- tends over the tear bar (refer to Figure 8).
12.Lift to hook
the top of the media access door over the top cover.
13. Push in the | Tear Bar |
bottom of the |
|
media access |
|
door to close. |
|
14. Turn on the |
|
printer or press |
|
the Feed button |
|
if the printer is |
|
already on. | FIGURE 8 |
|
12 | PA/PT400 & PA/PT 403 User’s Guide |