NOTE. If ribbon is loaded (PTseries only), remove the ribbon cartridge before loading the media.
1.Raise the media access door by lifting at the notch until it un- hooks from the top cover (refer to Figure 4).
2.Swing the media access door open to expose the media com- partment (refer to Figure 5).
3.Pivot the top cover to reveal the printhead.
4.Lift the printhead until you feel it “lock” into place. Be careful not to force the printhead past this position!
WARNING: NEVER touch the thermal print elements on 
the underside of the printhead. Under certain conditions, they can be very hot! Also, dirt or moisture from your hands can damage the prlnthead!
5.Separate and hold open the media hangers (refer to Figure 11).
6.Place the plastic media core (refer to Figure 11) onto the media hangers.
NOTE. The plastic media core can be obtained from an authorized Zebra supplies reseller.
7.Release the media hangers so the plastic media core locks into the correct position.
8.Place the fanfold media in the fanfold media tray.
Media
Guides
Media
Hangers
Plastic
Media
Core
FIGURE 11
16 | PA/PT400 & PA/PT 403 User’s Guide |