
Calibration
Auto Calibration
NOTE., The printer will not auto calibrate when you are using
By default, this printer automatically sets the sensor levels for, and determines the length of, the label you are using. To auto calibrate:
1.Load the media according to the instructions in “Loading the Media” in Getting Ready to Print.
2.Turn on the printer or press the Feed button if the printer is al- ready on.
3.Some blank labels will feed, completing auto calibration.
4.If the Error LED begins flashing, refer to “Manual Calibration.”
Hints:
•Auto calibration only works when you are using
•When auto calibration is selected, it occurs when the printer is turned on (if the printhead has been opened), whenever an er- ror is cleared, or if the battery (or other power source) has been removed.
Manual Calibration
A manual calibration should be performed whenever you are using
1.Turn on the printer power.
2.Remove
3.Press and hold the Feed button until the Error LED flashes once, then twice. Release the button.
4.The printer will set the media sensor for the label backing you are using. After it is done making this adjustment, the roll will automatically feed until a label is positioned at the printhead.
5.A profile of the media sensor settings will print (similar to the example in Figure 26). Upon completion, the printer will save the new settings in memory and the printer is ready for normal operation.
28 | PA/PT400 & PA/PT 403 User’s Guide |