Getting Ready to Print

Battery

Installing the Battery

NOTE: Batteries are shipped uncharged.

1.Slide up the battery compartment door.

2.Insert the battery into the printer as shown in Figure 2, with the silver-colored battery contacts facing up.

3.After the battery is completely inserted, slide down the battery compartment door.

When the battery is first installed, the Power and Error LEDs will light approximately two seconds and then go off. If these lights do not go on the battery is not fully charged (see “Charging the Battery”).

Charging the Battery

Refer to Figure 3 (your battery charger may look slightly different than the ones illustrated).

1.With the battery installed in the printer, insert the connector of the battery charger into the receptacle on the side of the print- er.

2.If you are using a 120 VAC battery charger: plug the battery charger into an appropriate 120 VAC electrical outlet.

If you are using a universal battery charger: Make sure the sup-

PA/PT400 & PA/PT 403 User’s Guide

9