Zebra Technologies RP4T, QL420, Qln420 installation instructions Installing the Printer, QLn420

Installing the Printer

The QLn420, QL 420 or P4T Printer can now be installed in the Mobile Mount.

QLn420:

Peel adhesive backer from the (4) Foam Washers and apply to the Mounting Plate over the printer mounting holes as indicated in Figure 6. Secure the printer to the Mobile Mount Bracket with (2) #6-32 x 3/8”Screws, (2) #6-32 x1/2” Screws, Lock Washers and Flat Washer. Do not exceed an installation torque of 7 in/lb. [.79 Nm] on these screws.

QL 420:

Peel adhesive backer from the (4) Foam Washers and apply to the Mounting Plate over the printer mounting holes as indicated in Figure 7. Secure the printer to the Mobile Mount Bracket with (4) #8-32 x 3/8” Screws, Lock Washers and Flat Washers. Do not exceed an installation torque of 7 in/lb. [.79 Nm ] on these screws.

P4T:

Peel adhesive backer from (2) Foam Washers and apply to the Mounting Plate over the printer mounting holes as indicated in Figure 7. Secure the printer to the Mobile Mount Bracket with (2) #8-32 x 3/8” Screws, Lock Washers and Flat Washers. Do not exceed an installation torque of 7 in/lb. [.79 Nm ] on these screws.

Washer, Foam (p/n AT17342-1

4 p/u for QLn420*)

*4th Mounting Hole not visible

Data I/O Cable from terminal

•(2) #6-32 x 3/8” PAN Hd. Screw (p/n P1055997): Lower Mounting Holes

•(2) #6-32 x 1/2” PAN Hd. Screw (p/n P1054427): Upper Mounting Holes

•#8 Lock Washer (p/n 738002-06)

•#8 Flat Washer (p/n TH-WA0612)

(4 p/u for QLn420)

Plug from DC/DC module

1/4-20 x 1/2” Bolt, supplied with Mobile Mount Kit (p/n TH-SK2007)

Figure 6:

Printer Installation (P1050667-035 shown with QLn420)

Note: For customers who have the AK18296-3 kit and want to re-use it for the QLn420, they can order P1050667-037. This kit includes only the QLn420 mounting plate and associated hardware.

P1005089 Rev. C pg. 9 of 13