Zebra 6300 Printer User’s Guide

 

 

 

 

 

 

Ribbon requirements

 

Zebra recommends use of Zebra-brand ribbon which is inked

 

 

on the inside surface. (Use tape to see which side is inked.)

Fonts available

 

• CG Triumvirate Bold Condensed (6, 8, 10, 12, 14, 18 pt.)

 

 

• Zebra fonts A, B, C, D, E, H, GS, IBM Code Page 850 Inter-

 

 

national Characters, Graphics symbols

Bar codes available

 

• 2-digit and 5-digit supple-

• Industrial 2 of 5, Standard 2

 

 

mental code

of 5

 

 

• Codabar (supports ratios of

• Interleaved 2 of 5 (supports

 

 

2:1 to 3:1)

ratios of 2:1 to 3:1, Modulus

 

 

• Code 11

10 Check Digit)

 

 

• Code 128 (supports serial-

• LOGMARS

 

 

ization in all subsets and

• MaxiCode

 

 

UCC Case Codes)

• MSI

 

 

• Code 39 (supports ratios of

• PDF 417

 

 

2:1 to 3:1)

• Plessey

 

 

• Code 93

• POSTNET

 

 

• EAN Versions 8 and 13,

• UPC Versions A and E, UPC

 

 

EAN Extensions

Extensions

 

 

 

Electrical

 

External 120 or 230 VAC power supply, depending on which

 

 

model you order. Additional custom line cords may also be

 

 

available.

 

Communications

 

36-pin Centronics™-compatible parallel port; RS-232 serial

 

 

port (DB-9 connector)

 

Parallel data cable

 

For maximum reliability, use a parallel data cable no longer

 

 

than 6 ft (1.8 m).

 

Agency approvals

 

• UL 544 Medical Equipment Standard Part 42.5

 

 

• CSA 22.2 No. 950 Canadian Safety Standard

 

 

• IEC 950/EN 60950 International Safety Standard

 

 

• FCC Part 15 Subpart B Electromagnetic Radiation Standard

 

 

• AAMI Medical Standard part 4.3.2

 

 

• UL 1950 Domestic Safety Standard

 

 

• SOR/88-475 Canadian Electromagnetic Radiation Standard

 

 

• EN50082-1 International Immunity Standard

 

 

• C.I.S.P.R.-22 Class B European Electromagnetic Radiation

 

 

Standard

 

Processor

 

32-bit microcontroller

 

Power line cord

 

• The overall length must be less than 12.5 ft (3.8 meters)

 

 

• It must be rated for at least 3 A, 250 V.

 

 

• The chassis ground (earth) MUST be connected to assure

 

 

safety and reduce electromagnetic interference. The ground

 

 

connection is handled by the third wire (earth) in the power

 

 

line cord. See Figure 9.

 

 

 

The AC power plug and IEC 320 connector must bear the cer-

 

 

tification mark of at least one international safety organization.

 

 

See Figure 10.

 

#