Installation

HDSTB Setup

-This TV can receive Digital Over-the-air/Cable signals without an external digital set-top box. However, if you do receive Digital signals from a digital set-top box or other digital external device, refer to the figure as shown below.

-This TV supports HDCP (High-bandwidth Digital Contents Protection) protocol for Digital Contents (480p,720p,1080i).

How to connect

Use the TV’s COMPONENT (Y, PB, PR) INPUT, RGB, HDMI1/DVI or HDMI2 jack for video connections, depending on your set-top box connec- tor. Then, make the corresponding audio connections.

Note: HDMI(High Definition Multimedia Interface): Input that accepts uncom- pressed digital signal and multi channel digital audio signal.

How to use

1.Turn on the digital set-top box. (Refer to the owner’s manual for the digital set-top box.)

2.Use TV/VIDEO on the Remote Control to select Component 1, Component 2, RGB-DTV, HDMI1/DVI or HDMI2 source.

Signal

Component 1/2

RGB-DTV,HDMI1/DVI,HDMI2

480i

Yes

No

480p

Yes

Yes

720p

Yes

Yes

1080i

Yes

Yes

 

 

 

Monitor Out Setup

The TV has a special signal output capability which allows you to hook up a second TV or monitor.

Connect the second TV or monitor to the TV’s MONITOR OUTPUT. See the Operating Manual of the second TV or monitor for further details regarding that device’s input settings.

Note

Component, RGB-PC/RGB-DTV, HDMI1/DVI,HDMI2, DTV input sources cannot be used for Monitor out.

RGB INPUT

PC/DTV

(XGA/

480p/

720p/

1080i)

RGB/DVI INPUT

(L)

AUDIO

(R)

VARIABLE

AUDIO OUT

(L)

AUDIO

(R)

S-VIDEO

MONITOR INPUT2 INPUT1 OUT

MONO

S-VIDEO

IN

(R) AUDIO (L)

VIDEO

14 DLP Projection TV

Page 14
Image 14
Zenith Z52SZ80, Z44SZ80 warranty Hdstb Setup, Monitor Out Setup