English

5. For safe operation

4.Check your equipment before operation, especially the muffler, air intakes and air filters.

WORKING PLAN

When planning your work schedule, allow plenty of time to rest. Limit the amount of time over which the product is to be used continuously to somewhere around 30 ~ 40 minutes per session, and take 10 ~ 20 minutes of rest between work sessions. Also try to keep the total amount of work performed in a single day under 2 hours or less.

FUEL

WARNING

To reduce the risk of fire and burn injury:

a)Handle fuel with care. It is highly flammable.

b)Do not smoke while handing fuel.

c)Do not refuel a hot engine.

d)Do not refuel a running engine.

e)Avoid spilling fuel or oil. Always wipe unit dry before using.

f)Move at least 10 ft. (3 meters) away from the fueling point before starting engine.

g)Always store gasoline in a container approved for flammable liquids.

h)Make sure the unit is properly assembled and in good operating condition.

BEFORE STARTING THE ENGINE

Each time before starting the engine, inspect the entire unit to see if every part is in good order and is securely tightened in place. If any damage is found in the fuel line, the exhaust line, or the ignition wiring, do not use the blower until it has been repaired.

IMPORTANT

Before starting operation, always make sure to check if any obstacles are left inside the volute case and net. The obstacles may cause damage on fan and volute case and serious injury.

14

Page 14
Image 14
Zenoah EBZ3000RH-CA manual Working Plan, Fuel, To reduce the risk of fire and burn injury, Before Starting the Engine