www.zephyronline.com
Use the high suction speed in cases of concentrated kitchen vapours. It is recommended that the cooker hood suction is switched on for 5 minutes prior to cooking and to leave in operation during cooking and for another 15 minutes approximately after terminating cooking.
Description of control panel:
A B C D E F
A- Lighting: dim lighting / full lighting /off (loop control) - Works even with hood in stand by and/or drawer closed.
B- Set Fan in Stand by (LED on the lower side of the display ON).
C- ON/OFF Timer for selected speed (visualizes the speed selected and flashing LED on the lower side of the display).
This knob permits the operation of the cooker hood for a established period: 20 minutes if the speed selected is 1
15 minutes if the speed selected is 2
10 minutes if the speed selected is 3
5 minutes if the boost speed P is selected.
D- Display showing: fan speed
Note: if in posses of the Remote Control (see paragraph "List of Part and Accessories") the display shows a flashing "b" this to indicate that the remote control battery must be replaced.
When the led in the lower right side is on, it indicates that the cooker hood is ready for operation (“standby” position), the flashing LED indicates that the timer has been activated for selected speed.
Warning!
The Charcoal filter saturation function is not activated.
In order to activate the charcoal filter saturation indicator, press buttons E and F simultaneously for 3 seconds. Initially, only letter F will be displayed, then after the 3 seconds have passed, letter C will be displayed as well, indicating that the carbon filter saturation control system is active.
To switch off the system,
E- Knob to decrease the speed: from boost speed P to speed level 1.
F- Knob to increase (standby) speed to boost speed P.
Attention! Boost speed P lasts 5 minutes after which the cooker hood automatically sets the speed to level 2 (suction power).
Controlling the range hood with sliding glass:
Closing the glass, all selected speed and lights switched off.
Hood retains last speed (except
If the hood fails to operate correctly, briefly disconnect it from the mains power supply for almost 5 sec. by pulling out the plug. Then plug it in again and try once more before contacting the Technical Assistance Service.
Warning!
Always press the fan off button A before disconnecting the hood from the mains supply.
Reset filter saturation signal
Press knob B for about 3 seconds.
The letter F and/or C will disappear from the display.
Controls
15
