Zephyr ES1-30AW, ES1-E30AS, ES1-E30AB installation instructions Cleaning CONT’D, Don’t

10. CLEANING (CONT’D)

To remove the blower wheel, first take off its intake ring. Then remove the blower wheel by pulling it down smoothly.

D

C

HD0156

NOTE: Do not try to remove the black part (C) attached to the bottompanel.

When reinstalling the blower wheel, make sure the small tab (D) will fit into one hole of the motor.

STAINLESS STEEL CLEANING:

Do:		Don’t:
•	Regularly wash surfaces with clean	•	Do not use any steel or stainless steel
	cloth or rag soaked with warm water		wool or any other scrapers to remove
	and mild soap or liquid dish detergent.		stubborn dirt.
•	Always clean in the direction of original	•	Do not use any harsh or abrasive
	polish lines.		cleansers.
•	Always rinse well with clear water (2 or 3	•	Do not allow dirt to accumulate.
	times) after cleaning. Wipe completely dry.	•	Do not let plaster dust or any other
•	You may also use a specialized
			construction residues reach the hood.
	household stainless steel cleaner.
			During construction or renovation,cover
			the hood to make sure no dust adheres
			to stainless steel surface.

Avoid: when choosing a detergent

-Any cleaners that contain bleach will attack stainless steel.

-Any products containing: chloride, fluoride, iodide, bromide will deteriorate surfaces rapidly.

-Any combustible products used for cleaning such as acetone, alcohol, ether, benzol, etc., are highly explosive and should never be used close to a range.

ENAMEL FINISH:

Clean with warm water and mild detergent only. If discoloration occurs, use a good enamel polish such as automotive polish. (DO NOT use rough abrasive cleaner or porcelain cleaner.)

- 10 -