ZyWALL 10~100 Series Internet Security Gateway
Chart
LOG MESSAGE | DESCRIPTION |
|
|
!! Remote IP <IP start> / <IP end> | If the security gateway is “0.0.0.0”, the ZyWALL will |
conflicts | use the peer’s “Local Addr” as its “Remote Addr”. If a |
| peer’s “Local Addr” range conflicts with other |
| connections, then the ZyWALL will not accept VPN |
| connection requests from this peer. |
|
|
!! Active connection allowed | The ZyWALL limits the number of simultaneous Phase |
exceeded | 2 SA negotiations. The IKE key exchange process fails |
| if this limit is exceeded. |
|
|
!! IKE Packet Retransmit | The ZyWALL did not receive a response from the peer |
| and so retransmits the last packet sent. |
!! Failed to send IKE Packet | The ZyWALL cannot send IKE packets due to a |
| network error. |
!! Too many errors! Deleting SA | The ZyWALL deletes an SA when too many errors |
| occur. |
!! Phase 1 ID type mismatch | The ID type of an incoming packet does not match the |
| local's peer ID type. |
!! Phase 1 ID content mismatch | The ID content of an incoming packet does not match |
| the local's peer ID content. |
!! No known phase 1 ID type | The ID type of an incoming packet does not match any |
found | known ID type. |
Peer ID: IP address type <IP | The IP address type or IP address of an incoming |
address> | packet does not match the peer IP address type or IP |
| address configured on the local router. The log |
| displays the IP address type and IP address of the |
| incoming packet. |
|
|
vs. My Remote <IP address> | The IP address type or IP address of an incoming |
| packet does not match the peer IP address type or IP |
| address configured on the local router. The log |
| displays this router’s configured remote IP address |
| type or IP address that the incoming packet did not |
| match. |
Log Descriptions |