ZyXEL Communications quick start Configuring A-6000, The Indoor Unit, Default Configuration

Figure 3-2 Top panel of outdoor unit				Figure 3-3 Bottom panel of outdoor unit
			Table 3-1 Connectors of outdoor unit
Function	Location	Label	Interface		Description
Antenna	Top		N male RF connector with		Connecting to the outdoor antenna
			special water proof
Signal &	Bottom		8-pin female connector		Connecting to the indoor interface unit
Power			with special water proof		supplying the power and signal
Antenna	Bottom		8-pin male connector with		Connecting to AK-100 for antenna
alignment			special water proof		alignment

3.3.The Indoor Unit

The indoor unit is a network/power injector which is used to combine the signal stream and DC power into single category-5 cable to connect outdoor unit. It has three ports.

Table 3-2 Connectors of indoor unit

Function	Name	Connector	Description
Power	POWER	Power jack	Connecting to the outdoor antenna
Ethernet	TO LAN	RJ45	User for CPE connection via straight through
			Ethernet cable
Signal & Power	TO RADIO	RJ45	Used for outdoor unit connection via special
			waterproof category-5 cable

4. Configuring A-6000

This guide shows you the default factory configuration of A-6000 and how to configure the A-6000 for appropriate operation at the first time. See the User’s Guide for configuration details.

4.1.Default Configuration

The A-6000 is shipped with following factory default configurations:

Table 4-1 Default configuration

	BU	RU
LAN IP	192.168.1.1	192.168.1.1
Subnet Mask	255.255.255.0	255.255.255.0
Wireless ESSID	Wireless	Wireless
Username/Password	admin/1234	admin/1234

7