Chapter 4 The Web Configurator
Table 4 Navigation Panel Links (continued)
LINK | DESCRIPTION |
Statistics | Use these screen to view system statistics such as the number of packets received |
| on the switch, collisions and errors and to view statistics for individual ports on the |
| switch. |
|
|
VLAN | Use these screens to create new IEEE 802.1Q VLANs as well as view the status |
| and edit existing IEEE 802.1Q VLANs on the switch. |
|
|
Trunk Groups | Use these screens to create trunk groups and add/remove ports from existing trunk |
| groups. |
|
|
Mirror | Use this screen to copy traffic from one port or ports to another port in order that |
| you can examine the traffic from the first port without interference. |
|
|
QoS | Use these screens to configure queuing with associated queue weights for the |
| switch. |
|
|
Rate | Use these screens to specify bandwidth limits and storm control limits for the |
| switch. |
|
|
Port Rate | Use this screen to cap the maximum bandwidth allowed from specified source(s) to |
| specified destination(s). |
|
|
Storm | Use this screen to cap the rate of broadcast, multicast and unknown unicast |
Control | packets the switch will allow on individual ports. |
|
|
L2 Address | Use these screens to view and manage the MAC address table. |
|
|
Management | Use this screen to add, delete or look up MAC addresses in the MAC address |
| table. |
|
|
Display | Use this screen to view the entries in the MAC address table. |
|
|
Cable Diagnostic | Use this screen to perform cable testing on individual ports. |
|
|
Auto DoS | Use these screens to activate security features against Denial of Service (DoS) |
| attacks. |
|
|
Auto VoIP | Use these screens to configure settings that automatically give higher priority to |
| Voice over Internet Protocol (VoIP) traffic. |
|
|
Logging | Use these screens to configure log settings and view system logs. |
|
|
Settings | Use this screen to configure which events the switch should log. |
|
|
RAM Logs | Use this screen to configure logs which are saved to volatile memory. These logs |
| are cleared when the switch is rebooted. |
|
|
Flash Logs | Use this screen to configure logs which are saved to |
| view these logs even after a switch is rebooted. |
|
|
SNMP | Use these screens to configure SNMP management settings. |
|
|
Engine ID | Use this screen to configure SNMP engine ID. |
|
|
Group | Use this screen to configure groups with different access rights for SNMP |
| management. |
|
|
User | Use this screen to create users and assign them to |
|
|
Community | Use this screen to define security parameters for SNMP v1 and SNMP v2c. |
|
|
Trap Station | Use this screen to configure settings that define when notifications are sent to an |
| external management station. |
|
|
Use this screen to configure Remote Network Monitoring Management Information | |
| Base (RMON MIB) settings. |
|
|
Dynamic ARP | Use these screens to enable and configure ARP table settings. |
|
|
Settings | Use this screen to configure ARP table settings. |
|
|
46 |
| |
| ||
|
|
|