
Chapter 15 Remote Management Configuration
15.6.3 Configuring SNMPSee Section 15.1 on page 195 for background information. Use this screen to change your ZyXEL Device’s SNMP settings. Click Advanced > Remote MGMT > SNMP. The screen appears as shown.
Figure 104 Remote MGMT > SNMP
The following table describes the labels in this screen.
Table 76 Remote MGMT > SNMP
LABEL | DESCRIPTION |
SNMP |
|
|
|
Port | You may change the server port number for a service if needed, however you |
| must use the same port number in order to use that service for remote |
| management. |
|
|
Access Status | Select the interface(s) through which a computer may access the ZyXEL Device |
| using this service. |
|
|
Secured Client IP | A secured client is a “trusted” computer that is allowed to communicate with the |
| ZyXEL Device using this service. |
| Select All to allow any computer to access the ZyXEL Device using this service. |
| Choose Selected to just allow the computer with the IP address that you specify |
| to access the ZyXEL Device using this service. |
|
|
SNMP |
|
Configuration |
|
|
|
Get Community | Enter the Get Community, which is the password for the incoming Get and |
| GetNext requests from the management station. The default is public and |
| allows all requests. |
|
|
Set Community | Enter the Set community, which is the password for incoming Set requests |
| from the management station. The default is public and allows all requests. |
|
|
Trap Community | Type the trap community, which is the password sent with each trap to the |
| SNMP manager. The default is public and allows all requests. |
|
|
Trap Destination | Type the IP address of the station to send your SNMP traps to. |
|
|
Apply | Click Apply to save your customized settings and exit this screen. |
|
|
Cancel | Click Cancel to begin configuring this screen afresh. |
|
|
| 201 |
|
|