ZyXEL Communications P-793H 23.1.1 2wire-2lineService Mode

Chapter 23 WAN Setup

23.1.1 2wire-2line Service Mode

From the main menu, enter 2 to open menu 2, then select 2wire-2linein the Service Mode field to see the screen as shown below.

Figure 143 Menu 2: 2wire-2line Service Mode

Menu 2	- WAN Setup
Service Mode= 2wire-2line
Service Type= N/A		Rate Adaption= Enable
Rate Adaption= Disable		Rate Adaption= Enable
Transfer Max	Rate(Kbps)= 4480	Transfer Max Rate(Kbps)= 5696
Transfer Min	Rate(Kbps)= 4480	Transfer Min Rate(Kbps)= 3200
Standard Mode= ANSI(ANNEX_A)		Standard Mode= ANSI(ANNEX_A)
Wan Backup Setup:
Check Mechanism = DSL Link
Check WAN IP	Address1 = 0.0.0.0
Check WAN IP	Address2 = 0.0.0.0
Check WAN IP	Address3 = 0.0.0.0

KeepAlive Fail Tolerance = 0

Recovery Interval(sec) = 0

ICMP Timeout(sec) = 0

Traffic Redirect = No

Dial Backup = No

The following table describes the fields in this screen.

Table 95 Menu 2: 2wire-2line Service Mode

FIELD	DESCRIPTION
Service Mode	Press [SPACE BAR] to select 2wire-2line service mode. This means you are
	establishing a point-to-2point connection. See Chapter 4 on page 63 for more
	background information. In 2wire-2line mode, the maximum data rate is up to 5.69
	Mbps for each DSL connection.

Service Type	The ZyXEL Device automatically acts as a server in 2wire-2line mode.

Rate Adaption	The field on the left refers to DSL 1 connection and the field on the right refers to
	DSL 2 connection. Press [SPACE BAR] to let the ZyXEL Device adjust the speed of
	its connection to that of the other device.

Transfer Max	The field on the left refers to DSL 1 connection and the field on the right refers to
Rate(Kbps)	DSL 2 connection. Press [SPACE BAR] to set the maximum rate at which the ZyXEL
	Device sends and receives information. If you enable Rate Adaption, the ZyXEL
	Device adjusts to the speed of the other device and may exceed this rate.

Transfer Min	The field on the left refers to DSL 1 connection and the field on the right refers to
Rate(Kbps)	DSL 2 connection. Press [SPACE BAR] to set the minimum rate at which the ZyXEL
	Device sends and receives information. If you enable Rate Adaption, the ZyXEL
	Device adjusts to the speed of the other device and may transfer information at less
	than this rate.

Standard Mode	The field on the left refers to DSL 1 connection and the field on the right refers to
	DSL 2 connection. Press [SPACE BAR] to select the operational mode the ZyXEL
	Device uses in the DSL connection.

Wan Backup
Setup

	251
P-793H User’s Guide	251