ZyXEL
You can easily check to see if this has happened. WPS works between only two devices simultaneously, so if another device has enrolled your device will be unable to enroll, and will not have access to the network. If this happens, open the access point’s configuration interface and look at the list of associated clients (usually displayed by MAC address). It does not matter if the access point is the WPS registrar, the enrollee, or was not involved in the WPS handshake; a rogue device must still associate with the access point to gain access to the network. Check the MAC addresses of your wireless clients (usually printed on a label on the bottom of the device). If there is an unknown MAC address you can remove it or reset the AP.
3.4 Introduction to OTIST
In a wireless network, the wireless clients must have the same SSID and security settings as the access point (AP) or wireless router (we will refer to both as “AP” here) in order to associate with it. Traditionally this meant that you had to configure the settings on the AP and then manually configure the exact same settings on each wireless client.
OTIST
3.4.1 Enabling OTIST
You must enable OTIST on both the AP and wireless client before you start transferring settings.
We use the
Note: The AP and wireless client(s) MUST use the same Setup key.
3.4.1.1 AP
On the
Hold in the OTIST button for about two seconds.
Chapter 3 Wireless LAN Network | 47 |