Husqvarna YTH22V42 To Remove Wheel See Fig, Front Wheel TOE-IN/CAMBER, Replacing Battery See Fig

Page 23

SERVICE AND ADJUSTMENTS

TO REMOVE WHEEL (See Fig. 33)

•Block up axle securely.

•Remove axle cover, retaining ring and washers to allow wheel removal (rear wheel contains a square key - Do not lose).

•Repair tire and reassemble.

•On rear wheels only: align grooves in rear wheel hub and axle. Insert square key.

•Replace washers and snap retaining ring securely in axle groove.

•Replace axle cover.

NOTE: To seal tire punctures and prevent flat tires due to slow leaks, tire sealant may be purchased from your local parts dealer. Tire sealant also prevents tire dry rot and corrosion.

RETAINING WASHERS

RING

AXLE

COVER

SQUARE KEY (REAR

WHEEL ONLY)

Fig. 33

FRONT WHEEL TOE-IN/CAMBER

Your new tractor front wheel toe-in and camber is set at the factory and is normal. The front wheel toe-in and camber are not adjustable. If damage has occurred to affect the factory set front wheel toe-in or camber, contact a qualified service center.

TO START ENGINE WITH A WEAK BATTERY (See Fig. 34)

WARNING: Lead-acid batteries generate explosive gases. Keep sparks, flame and smoking materials away from batteries. Always wear eye protection when around batteries.

If your battery is too weak to start the engine, it should be recharged. (See "BATTERY" in the MAINTENANCE sec- tion of this manual).

If “jumper cables” are used for emergency starting, follow this procedure:

IMPORTANT: YOUR TRACTOR IS EQUIPPED WITH A 12 VOLT SYSTEM. THE OTHER VEHICLE MUST ALSO BE A 12 VOLT SYSTEM. DO NOT USE YOUR TRACTOR BATTERY TO START OTHER VEHICLES.

TO ATTACH JUMPER CABLES -

•Connect one end of the RED cable to the POSITIVE

(+)terminal of each battery(A-B), taking care not to short against tractor chassis.

•Connect one end of the BLACK cable to the NEGATIVE (-) terminal (C) of fully charged battery.

•Connect the other end of the BLACK cable (D) to good chassis ground, away from fuel tank and battery.

TO REMOVE CABLES, REVERSE ORDER -

•BLACK cable first from chassis and then from the fully charged battery.

•RED cable last from both batteries.

WEAK OR

FULLY CHARGED

DEAD BATTERY

BATTERY

Fig. 34

REPLACING BATTERY (See Fig. 35)

WARNING: Do not short battery termi- nals by allowing a wrench or any other object to contact both terminals at the same time. Before connecting battery, remove metal bracelets, wristwatch bands, rings, etc. Positive terminal must be connected first to prevent sparking from accidental grounding.

•Lift seat pan to raised position.

•Disconnect BLACK battery cable first then RED battery cable and carefully remove battery from tractor.

•Install new battery with terminals in same position as old battery.

•First connect RED battery cable to positive (+) terminal with bolt and nut as shown. Tighten securely. Slide terminal cover over terminal.

•Connect BLACK grounding cable to negative (-) ter- minal with remaining bolt and nut. Tighten securely.

•Lower seat pan.

SEAT PAN

 

TERMINAL

NUT

COVER

BOLT

 

POSITIVE

NEGATIVE

(RED)

(BLACK)

CABLE

CABLE

02603

 

Fig. 35

23

Page 22 Page 24
Image 23
Page 22 Page 24
Contents English/Spanish Operator’s Manual Manual de OperarioII. Slope Operation Safety RulesSafe Operation Practices for Ride-On Mowers General OperationIV. Towing ServiceGeneral Service III. ChildrenTable of Contents Toremovetractorfromcarton AssemblyTools Required for Assembly Unassembled PartsCheck Brake System Check Tire PressureCheck Deck Levelness Check for Proper Position of ALL BeltsOperation Know Your Tractor To USE Throttle Control D See Fig HOW to USE Your TractorTo SET Parking Brake See Fig Stopping See FigTo Operate Mower To Adjust Mower Cutting Height See FigTo Adjust Gauge Wheels See Fig To USE Cruise Control J See FigTo Transport See Figs Service REMINDER/HOUR MeterReverse Operation System ROS To Operate on HillsTo Start Engine See Fig Before Starting the EngineCheck Engine OIL Level ADD GasolinePurge Transmission Mowing TipsSchedule MaintenanceMaintenance General RecommendationsBlade Removal See Fig BatteryTractor Blade CareTransaxle Pump Fluid EngineBelts Transaxle CoolingCleaning Deck Washout Port See Fig To Remove Mower See Fig To Install Mower See FigInstall belt on engine pulley M, in belt keepers G To Level Mower To Replace Motion Drive Belt See Fig Belt InstallationTo Replace Mower Blade Drive Belt See Fig To Check BrakeFront Wheel TOE-IN/CAMBER To Start Engine with a Weak Battery See FigReplacing Battery See Fig To Remove Wheel See FigTransmission Cylinders OtherFuel System Engine OILProblem Cause Correction TroubleshootingEngine continues Fold Along This Dotted Line Degree Slope Only Ride UP and Down Hill Not Across Hill Degrees MAXII. Funcionamiento EN Pendientes Reglas DE SeguridadAdvertencia Funcionamiento GeneralOperaciones DE Servicio Generales III. NiñosIV. Remolque ServicioResponsabilidades DEL Cliente Identificación DE ProblemasTabla DE Materias Especificaciones DEL ProductoVerifique LA Batería Vea Fig Pedazos Para LA MontajeMontaje Desempaque LA Caja DE CartónRevisión DEL Sistema DE Frenos Revisión DE LA Presión DE LAS LlantasRevisión DE LA Nivelación DEL CON- Junto Revisión DE LA Posición Adecuada DE Todas LAS CorreasTractor y/o al motor OperaciónDispositivo DE Aviso DE Servicio / Cronómetro Moversehaciaadelanteyhaciaatrás Vea Fig Como Usar SU TractorPara Ajustar EL Freno DE ESTACIONA- Miento Vea Fig Parada Vea FigPara Operar LA Segadora Utilizar EL Mando Crucero Vea FigPara Ajustar LAS Ruedas Calibradoras Vea FigPara Transportar Vea Fig Para Parar LAS Cuchillas DE LA SegadoraFuncionamiento Atrás ROS Vea Fig Para Operar EN CerrosAgregue Gasolina Antes DE Hacer Arrancar EL MotorMecanismo DE Aviso DE Servicio / Cronómetro Revise EL Nivel DE Aceite DEL MotorCalentamiento Para LA Transmision Automatica Purgar LA TransmisiónTabla DE Lubricación MantenimentoLlantas Cuidado DE LA CuchillaBatería Operación DEL FrenoLubricación CorreasEnfriamiento DEL Transeje Sistema DE Enfriamiento DE Aire Filtro DE Aceite DEL MotorFiltro DEL Aire Limpieza DE LA Rejilla DE AirePuerto DE Lavado DE LA Cubierta Vea Fig Para Desmontar LA Cortadora DE Césped Vea Fig Servicio Y AjustesConecte el fin de la primavera de cable de embrague Regulación Visual DE Lado a Lado Vea Fig Para Nivelar LA SegadoraRemoción DE LA Correa Para Reemplazar LA Correa DE TRANS- Misión Vea FigPara Hacer Arrancar EL Motor CON UNA Batería Baja Vea Fig Controlar Y Ajustar EL FrenoImpresión / Inclinación DE LAS Ruedas Delanteras REMOCIÓN/REEMPLAZO DE LA Transmisión Para Cambiar LA Bombilla DE LA LUZ DelanteraEntrecierre Y Relés Para Cambiar EL FusibleOtros AlmacenamientoMotor Problema Causa Corrección Identificación DE ProblemasIdentificación DE Problemas Pendiente 08/24/2011 CL
Related manuals
Manual 44 pages 20.69 Kb Manual 52 pages 16.58 Kb

YTH22V42 specifications

The Husqvarna YTH22V42 is a versatile and robust riding mower designed to meet the needs of homeowners looking for efficiency and durability in lawn care. This model is equipped with a powerful 22-horsepower Kohler engine, delivering reliable performance and enabling easy handling of various terrains. With its automatic transmission, operators can simply push a pedal to control the speed, providing a smooth and enjoyable mowing experience.

One of the standout features of the YTH22V42 is its 42-inch cutting deck, which allows for a wide cutting path, making it suitable for medium to large-sized yards. The cutting deck is reinforced, ensuring longevity and durability, while its air induction technology enhances airflow for a clean and even cut. The cutting height can be easily adjusted with a lever, offering six different settings from 1 to 4 inches.

Another significant characteristic of the YTH22V42 is its ease of use. The ergonomic design of the seat and steering wheel enhances comfort during longer mowing sessions. The mower is equipped with intuitive controls that make it easy for users of all experience levels to operate. Additionally, the unit features built-in anti-scalp wheels to protect the lawn from damage while trimming.

The Husqvarna YTH22V42 also boasts several innovative technologies. The ReadyStart system ensures an easy, no-prime starting of the engine, significantly reducing preparation time before mowing. The mower's compact design allows for easy maneuverability in tight spaces, making it effective for navigating around landscaping or garden features.

Furthermore, the YTH22V42 is compatible with Husqvarna’s extensive range of accessories, enhancing its versatility. From mulching kits to rear baggers, users can customize their mowing experience according to their specific lawn care needs.

In terms of maintenance, the YTH22V42 features a deck washout port, which simplifies cleaning under the cutting deck after use, prolonging the mower's lifespan and ensuring consistent performance. Additionally, the mower's robust construction ensures it can withstand the rigors of regular use.

Overall, the Husqvarna YTH22V42 combines power, comfort, and technology, making it an excellent choice for homeowners seeking a reliable and efficient riding mower. Its thoughtful design and advanced features position it as a leading option in the market, perfect for those looking to maintain a beautiful lawn with ease.
Top Page Image Contents