Husqvarna YTH22V42 warranty Other, Fuel System, Engine OIL, Cylinders

Page 25

STORAGE

Immediately prepare your tractor for storage at the end of the season or if the tractor will not be used for 30 days or more.

WARNING: Never store the tractor with gasoline in the tank inside a building where fumes may reach an open flame or spark. Allow the engine to cool before storing in any enclosure.

TRACTOR

Remove mower from tractor for winter storage. When mower is to be stored for a period of time, clean it thoroughly, remove all dirt, grease, leaves, etc. Store in a clean, dry area.

•Clean entire tractor (See “CLEANING” in the Maintenance section of this manual).

•Inspect and replace belts, if necessary (See belt replacement instructions in the Service and Adjustments section of this manual).

•Lubricate as shown in the Maintenance section of this manual.

•Be sure that all nuts, bolts and screws are securely fastened. Inspect moving parts for damage, breakage and wear. Replace if necessary.

•Touch up all rusted or chipped paint surfaces; sand lightly before painting.

BATTERY

•Fully charge the battery for storage.

•After a period of time in storage, battery may require recharging.

•To help prevent corrosion and power leakage during long periods of storage, battery cables should be disconnected and battery cleaned thoroughly (see “TO CLEAN BATTERY AND TERMINALS” in the Maintenance section of this manual).

•After cleaning, leave cables disconnected and place cables where they cannot come in contact with battery terminals.

•If battery is removed from tractor for storage, do not store battery directly on concrete or damp surfaces.

ENGINE

FUEL SYSTEM

IMPORTANT: IT IS IMPORTANT TO PREVENT GUM DEPOSITS FROM FORMING IN ESSENTIAL FUEL SYSTEM PARTS SUCH AS CARBURETOR, FUEL FILTER, FUEL HOSE, OR TANK DURING STORAGE. ALSO, EXPERIENCE INDICATES THAT ALCOHOL BLENDED FUELS (CALLED GASOHOL OR USING ETHANOL OR METHANOL) CAN ATTRACT MOISTURE WHICH LEADS TO SEPARATION AND FORMATION OF ACIDS DURING STORAGE. ACIDIC GAS CAN DAMAGE THE FUEL SYSTEM OF AN ENGINE WHILE IN STORAGE.

•Empty the fuel tank by starting the engine and let it run until the fuel lines and carburetor are empty.

•Never use engine or carburetor cleaner products in the fuel tank or permanent damage may occur.

•Use fresh fuel next season.

NOTE: Fuel stabilizer is an acceptable alternative in minimizing the formation of fuel gum deposits during storage. Add stabilizer to gasoline in fuel tank or storage container. Always follow the mix ratio found on stabilizer container. Run engine at least 10 minutes after adding stabilizer to allow the stabilizer to reach the carburetor. Do not empty the gas tank and carburetor if using fuel stabilizer.

ENGINE OIL

Drain oil (with engine warm) and replace with clean engine oil. (See “ENGINE” in the Maintenance section of this manual).

CYLINDER(S)

•Remove spark plug(s).

•Pour one ounce of oil through spark plug hole(s) into cylinder(s).

•Turn ignition key to “START” position for a few seconds to distribute oil.

•Replace with new spark plug(s).

OTHER

•Do not store gasoline from one season to another.

•Replace your gasoline can if your can starts to rust. Rust and/or dirt in your gasoline will cause problems.

•If possible, store your tractor indoors and cover it to give protection from dust and dirt.

•Cover your tractor with a suitable protective cover that does not retain moisture. Do not use plastic. Plastic cannot breathe which allows condensation to form and will cause your tractor to rust.

IMPORTANT: NEVER COVER TRACTOR WHILE ENGINE AND EXHAUST AREAS ARE STILL WARM.

25

Page 24 Page 26
Image 25
Page 24 Page 26
Contents English/Spanish Operator’s Manual Manual de OperarioSafe Operation Practices for Ride-On Mowers Safety RulesGeneral Operation II. Slope OperationGeneral Service ServiceIII. Children IV. TowingTable of Contents Tools Required for Assembly AssemblyUnassembled Parts ToremovetractorfromcartonCheck Deck Levelness Check Tire PressureCheck for Proper Position of ALL Belts Check Brake SystemOperation Know Your Tractor To SET Parking Brake See Fig HOW to USE Your TractorStopping See Fig To USE Throttle Control D See FigTo Adjust Gauge Wheels See Fig To Adjust Mower Cutting Height See FigTo USE Cruise Control J See Fig To Operate MowerReverse Operation System ROS Service REMINDER/HOUR MeterTo Operate on Hills To Transport See FigsCheck Engine OIL Level Before Starting the EngineADD Gasoline To Start Engine See FigPurge Transmission Mowing TipsMaintenance MaintenanceGeneral Recommendations ScheduleTractor BatteryBlade Care Blade Removal See FigBelts EngineTransaxle Cooling Transaxle Pump FluidCleaning Deck Washout Port See Fig To Remove Mower See Fig To Install Mower See FigInstall belt on engine pulley M, in belt keepers G To Level Mower To Replace Mower Blade Drive Belt See Fig Belt InstallationTo Check Brake To Replace Motion Drive Belt See FigReplacing Battery See Fig To Start Engine with a Weak Battery See FigTo Remove Wheel See Fig Front Wheel TOE-IN/CAMBERTransmission Fuel System OtherEngine OIL CylindersProblem Cause Correction TroubleshootingEngine continues Fold Along This Dotted Line Degree Slope Only Ride UP and Down Hill Not Across Hill Degrees MAXAdvertencia Reglas DE SeguridadFuncionamiento General II. Funcionamiento EN PendientesIV. Remolque III. NiñosServicio Operaciones DE Servicio GeneralesTabla DE Materias Identificación DE ProblemasEspecificaciones DEL Producto Responsabilidades DEL ClienteMontaje Pedazos Para LA MontajeDesempaque LA Caja DE Cartón Verifique LA Batería Vea FigRevisión DE LA Nivelación DEL CON- Junto Revisión DE LA Presión DE LAS LlantasRevisión DE LA Posición Adecuada DE Todas LAS Correas Revisión DEL Sistema DE FrenosTractor y/o al motor OperaciónDispositivo DE Aviso DE Servicio / Cronómetro Para Ajustar EL Freno DE ESTACIONA- Miento Vea Fig Como Usar SU TractorParada Vea Fig Moversehaciaadelanteyhaciaatrás Vea FigPara Ajustar LAS Ruedas Utilizar EL Mando Crucero Vea FigCalibradoras Vea Fig Para Operar LA SegadoraFuncionamiento Atrás ROS Vea Fig Para Parar LAS Cuchillas DE LA SegadoraPara Operar EN Cerros Para Transportar Vea FigMecanismo DE Aviso DE Servicio / Cronómetro Antes DE Hacer Arrancar EL MotorRevise EL Nivel DE Aceite DEL Motor Agregue GasolinaCalentamiento Para LA Transmision Automatica Purgar LA TransmisiónTabla DE Lubricación MantenimentoBatería Cuidado DE LA CuchillaOperación DEL Freno LlantasEnfriamiento DEL Transeje CorreasLubricación Filtro DEL Aire Filtro DE Aceite DEL MotorLimpieza DE LA Rejilla DE Aire Sistema DE Enfriamiento DE AirePuerto DE Lavado DE LA Cubierta Vea Fig Para Desmontar LA Cortadora DE Césped Vea Fig Servicio Y AjustesConecte el fin de la primavera de cable de embrague Regulación Visual DE Lado a Lado Vea Fig Para Nivelar LA SegadoraRemoción DE LA Correa Para Reemplazar LA Correa DE TRANS- Misión Vea FigImpresión / Inclinación DE LAS Ruedas Delanteras Controlar Y Ajustar EL FrenoPara Hacer Arrancar EL Motor CON UNA Batería Baja Vea Fig Entrecierre Y Relés Para Cambiar LA Bombilla DE LA LUZ DelanteraPara Cambiar EL Fusible REMOCIÓN/REEMPLAZO DE LA TransmisiónMotor AlmacenamientoOtros Problema Causa Corrección Identificación DE ProblemasIdentificación DE Problemas Pendiente 08/24/2011 CL
Related manuals
Manual 44 pages 20.69 Kb Manual 52 pages 16.58 Kb

YTH22V42 specifications

The Husqvarna YTH22V42 is a versatile and robust riding mower designed to meet the needs of homeowners looking for efficiency and durability in lawn care. This model is equipped with a powerful 22-horsepower Kohler engine, delivering reliable performance and enabling easy handling of various terrains. With its automatic transmission, operators can simply push a pedal to control the speed, providing a smooth and enjoyable mowing experience.

One of the standout features of the YTH22V42 is its 42-inch cutting deck, which allows for a wide cutting path, making it suitable for medium to large-sized yards. The cutting deck is reinforced, ensuring longevity and durability, while its air induction technology enhances airflow for a clean and even cut. The cutting height can be easily adjusted with a lever, offering six different settings from 1 to 4 inches.

Another significant characteristic of the YTH22V42 is its ease of use. The ergonomic design of the seat and steering wheel enhances comfort during longer mowing sessions. The mower is equipped with intuitive controls that make it easy for users of all experience levels to operate. Additionally, the unit features built-in anti-scalp wheels to protect the lawn from damage while trimming.

The Husqvarna YTH22V42 also boasts several innovative technologies. The ReadyStart system ensures an easy, no-prime starting of the engine, significantly reducing preparation time before mowing. The mower's compact design allows for easy maneuverability in tight spaces, making it effective for navigating around landscaping or garden features.

Furthermore, the YTH22V42 is compatible with Husqvarna’s extensive range of accessories, enhancing its versatility. From mulching kits to rear baggers, users can customize their mowing experience according to their specific lawn care needs.

In terms of maintenance, the YTH22V42 features a deck washout port, which simplifies cleaning under the cutting deck after use, prolonging the mower's lifespan and ensuring consistent performance. Additionally, the mower's robust construction ensures it can withstand the rigors of regular use.

Overall, the Husqvarna YTH22V42 combines power, comfort, and technology, making it an excellent choice for homeowners seeking a reliable and efficient riding mower. Its thoughtful design and advanced features position it as a leading option in the market, perfect for those looking to maintain a beautiful lawn with ease.
Top Page Image Contents